Quick reference guide | Chart |
PROGRAMME SELECTION BUTTON Push “Programs” button (repeatedly) until the indicator of the required programme lights up (see “Table of programmes” below).
START/RESUME BUTTON
Push this button to start the selected programme: the indicator lights up and goes off at the end of the programme. When the door is opened during a washing cycle, the cycle is temporarely paused: the Start indicator blinking. To restart the cycle close the door and push Start button again.
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ
THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING
ANY BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF ANY CYCLE IS STARTED.
BUTTON 
Pushthisbuttontoswitchonorswitchoffthecontrolpanel. If pressed when a programme is running it cancels the programme ongoing.
If the indicator flashes repeatedly, see page 5 - chapter ”What to do if ...”.
| Table of programmes | Deter- | Consumption | ||||
|
|
|
|
|
|
| |
P | Programmes |
| Loading instructions | gent | Litres | kWh | Minutes 1) |
|
| ||||||
1 | cold | Crockery to be washed later. | — | 5.0 | 0.02 | 10 | |
2 | Quickwash | 40°C | Lightly soiled crockery, with no dried- | X | 13.0 | 0.70 | 30 |
on food. | |||||||
3 | Eco 2) | 50°C | Normally soiled crockery. | X | 15.0 | 1.05 | 150 |
4 | Intensive | 70°C | Recommended programme for heavily |
|
|
|
|
soiled crockery, especially suitable for | X | 17.0 | 1.65 | 145 | |||
|
|
| pans and saucepans. |
|
|
|
|
5 | Half Load | 50°C | Ideal for washing a half load of lightly or | X | 13.0 | 1.00 | 130 |
normally soiled crockery. | |||||||
1)Programme data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional options) and may vary depending on conditions. Differences of up to 20 minutes are possible with sensor programmes as a result of the appliance’s automatic calibration system.
2)Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for
detailed information on the EN/Standard loading comparison test and other tests, contact the following address: | ADP 2315 | 5019 396 01824 |
“nk_customer@whirlpool.com”. |
GB
