Whirlpool ADP 2315 manual First time use, Daily check, Before the first wash or if water

How to set water hardness in order to always assure the best cleaning results First time use

Water hardness should be set only	-	Press and hold together Programs and	buttons for minimum 3 seconds.
before the first wash or if water
	-	Programmes LEDs will indicate the water hardness setting.
hardness has been changed
	- Press the Programs button to increase setting (when the level reaches 7, the next key press will set the level back to 1.
	- Wait 30 seconds (control panel switches off) or press START/Resume button to save setting.

1. Ask your water supply company what the water hardness is...	2. ...enter this value on	Suggestions for detergent use
	your dishwasher

						3 first PROGRAM LEDs			Gel or Powder
German		French		English	Water hardness	lit on the panel
									(rinse aid and	Tablets
degrees °dH		degrees °fH		degrees °eH	level	(see table of programmes)
									salt)
						P1	P2	P3
0	- 5	0	- 9	0 - 6.3	Soft	1
6 - 10		10	- 18	7 - 12.6	Medium	2
11	- 15	19	- 27	13.3 - 18.9	Average	3			go to step 1
										if water is
16	- 21	28	- 37	19.6 - 25.9	Medium-hard	4			(see “Daily
22	- 28	38	- 50	26.6 - 35	Hard	5			check”)	HARD extra salt
										needs to be
29	- 35	51	- 63	35.7 - 44.1	Very hard	6				added
										(go to step 1,
36	- 60	64 - 107		44.8 - 74.9	Extremely hard	7
										“Daily check”)

Water hardness level is factory set for medium-hard water (level 4).

Even if you use tablets which include salt, you must still add regeneration salt since such detergents are not effective enough at softening hard water.

At first time use, the salt reservoir has to be filled independently from water hardness level (see description below in step 1 “Daily check”).

Filling the salt reservoir - Dissolve limescale (not necessary if water hardness level is set to “soft”!) Daily check

1- salt reservoir

2- rinse aid dispenser

3- detergent dispenser

1	Visual indicator
	(depending
	on the model).
	Unscrew cap.

Fill the salt reservoir with water	Add salt (never add detergent!)
before the first wash only.	min. 1.5 kg / max. 2 kg

Screw on the cap. Salt residual around the cap need to be removed. Some salt reservoir have a level indicator integrated in the cap (see below how to check).

4- racks system

5,6,7,8- available functions on the panel

9- filters

10- spray arms

	(depending on the model)
The salt level indicator lamp may remain lit Salt indicator on the control panel		Salt indicator on the salt reservoir cap
at the end of several wash cycles. If the	The indicator lamp lights up when SALT	orange:	clear: NEEDS TO
water hardness level falls within category
	NEEDS TO BE ADDED.	OK.	BE ADDED
(soft), no salt is required.

GB -2-