TROUBLESHOOTING

COMMON WASHING PROBLEMS (CONT.)

 

 

 

 

 

Problem...

Cause...

Solution...

 

 

 

 

 

 

 

Won’t fill/rinse/agitate

Power cord not plugged in.

Plug in power cord.

 

 

 

 

or wrong tempera-

Timer (Cycle Control knob) dial

Turn timer knob to the right slightly

 

ture

 

is not lined up.

and pull to start.

 

 

 

 

Water inlet valve screens are plugged.

Clean screens.

 

 

Water is turned off.

Turn on water.

 

 

Hot and cold hoses are reversed.

Reverse hoses.

 

 

Inlet hose is kinked.

Straighten hose.

 

Washer stops

Power cord not plugged in.

Plug in power cord.

 

 

 

 

No power at plug.

Check electrical source or call

 

 

 

 

electrician.

Fuse blown or circuit breaker open.

Replace fuse or reset circuit breaker. If problem continues, call electrician.

Using an extension cord.

Timer dial is not lined up.

Do not use extension cords.

Turn timer to the right slightly and pull to start.

 

Timer knob not pulled out.

Set and pull out knob.

 

Machine is overloaded.

Wash smaller loads.

Water level seems

The top of the agitator is much higher

This is normal.

 

 

too low or washer

than the highest water level. This creates

 

 

 

not completely filling

a perception of the washer not being full.

 

 

 

 

 

 

 

 

 

 

Washer tub is

Tub is pulled forward when unloading.

Push tub to center before

 

crooked

 

starting.

 

Tub moves.

This is normal.

 

Unit not level.

Ensure front feet are installed

 

 

and nuts tightened. Level

 

 

washer. Reset rear leveling legs.

 

 

See Installation Instructions.

 

 

 

Residue or lint

Improper sorting.

Sort lint givers (towels, chenille)

 

on load

 

from lint takers (corduroy,

 

 

synthetics). Also sort by color.

 

Overloading.

Lint can be trapped in load if

 

 

overloaded. Wash smaller loads.

 

Paper or tissue in pockets.

Clean out pockets before washing.

 

Not enough detergent.

Use enough detergent to hold

 

 

lint in water.

 

Detergent not dissolving.

Use wash water warmer than 70°F

 

 

(21°C).

Wash water colder than 70°F (21°C).

Use wash water warmer than 70°F (21°C).

continued on next page

13

Page 13
Image 13
Whirlpool BYCW6292W0 Problem Cause Solution Won’t fill/rinse/agitate, Or wrong tempera, Ture, Washer stops, Washer tub is