Installing Your Freezer
In This Section
Page Cleanlng your treezer ............................ 5
Locating the proper electrkal supply ..5
|
| Page | |
Choosing | the proper locatlon .... | 5 | |
Completlng | the lnstallatlon | 6 | |
Proper installation of any appliance is very important. This section will tell you everything you need to know to install your freezer properly.
Cleaning your freezer
Clean your freezer thoroughly before using it.
1.Use a sponge, cloth or paper towel and mild detergent in warm water to dean outside and inside of freezer, door liner and gasket.
2.Rinse and dry thoroughly.
Locating the proper electrical supply
Recommended Groundlng Method
A 115 Volt, 60 Hz.. AC only 15 or 20 ampere fused and properly grounded electrical supply is required. It is recommended that a separate circuit serving only this appliance be provided. Use a receptacle which cannot be turned off with a switch or pull chain. Do not use an extension cord.
If your freezer does not have a plug with a grounding prong, connect the green ground wire (at the lower back of the freezer) to an
Sprang grounding type wall receptacle
grounding plug
Choosing the proper location
Read the following items before choosing the location for the freezer. See ‘Y=ompleting the installation” on page 6 before sliding the freezer into place.
1.Pick a safe place, indoors, away from flammables such as gasoline.
2.Check the strength of the floor. It should hold the weight of a fully loaded freezer.
3.Make sure the floor is level.
4.If you want to enclose your freezer, or store it under a counter, leave at least 1% inches of air space on all sides and behind the unit. Leave at least 4 inches of air space above the freezer.
