Connecting your portable dishwasher
A special adapter must be installed on the faucet before the dishwasher can
be connected. Complete instructions and the adapter are packed with your dishwasher,
When moving yourdishwasher, make sure the door is latched. Hold the dishwasher at the top front c
4. Empty any remaining water from the connector.
5.Unplug power supply cord and return to storage compartment.
6.Return hoses to storage compartment.
Before starting
1. Run water at faucet until it is hot. Turn it off
PULL RING
2. Pull hoses out of their storage compartment
on the back. | LOCKING COLLAR |
|
Electrical Connection
A power supply of 120 volts, 60Hz AC only, 15 or 20 amps, is required. For your personal safety,
this appliance must be grounded. This ap- pliance is equipped with a power supply cord having a
cle, grounded in accordance with the National Electrical Code and local codes and ordi- nances If a mating wall receptacle is not avail- able, it is the personal responsibility and obliga-
tion of the customer to have a properly grounded
HOSE CONNECTOR
3.Pull down on the locking collar while lifting the hose connector onto the faucet adapter.
4.When the connector snaps into place, re- lease the locking collar.
5.Turn the hot water on slowly until it is all the way on.
6.Plug in power supply cord.
7.See pages 8 and 9 to start the dishwasher.
While dishwasher is running
You can draw water from the faucet while the dishwasher is connected. DO NOT draw water while the dishwasher is filling or while water is being pumped out. (This helps prevent a low till when dishwasher is filling, or mixing drain water with tresh water.)
1.Press red button on hose connector to get the water you want. (The faucet is set on hot. Adjust faucet for the water you want.)
2.Be sure you return cold water to oft, and that hot water Is full on.
When cycle is finished
1.Turn hot water off. (This can be done after the last rinse.)
2.Press the red button on the connector to re- lease the water pressure.
3.Lift slightly on the hose connector while pull- ing down the locking collar. Pull down on
Power Supply Cord
DO NOT, UNDER ANY CIRCUMSTANCES, RE- MOVE THE POWER SUPPLY CORD GROUND PRONG.
Converting to built-in
Your Whirlpool Portable Dishwasher can be
converted to a
available at your Whirlpool dealer or autho-
rized
Caring for
simulated wood top
The simulated wood top can be used as a utility work surface for most kitchen jobs. It is stronger and more easily cleaned than genu- ine wood.
The top can be used as a cutting board. Knife marks will be visible but will not seriously damage top. Hot items from the oven can be placed on the top.
Clean with warm, soapy water. For
14
the connector.
