Dtsher not washing clean
Etching - permanent fllmlng which cannot be removed
Dlshes b lnterlor ot dlshwasher
p; or
Small dark spots on tlatware - stalnless steel, silver plate, or sterltng or rust spots on stainless steel
Bronze tarnish on silverplate
Water left in bottom of dishwasher
Water is not hot enough
Improper loading
Spray arm or arms not rotating freely
Not enough detergent or improper
detergent
“Old” detergent.
Water pressure may
be low, dishwasher is not filling properly
Too much detergent in soft water
Inadequate rinsing
Iron or manganese in water
Allowing salty or acidic foods such as
mayonnaise. vinegar. fruit juices. salad dressings, milk products to remain on flatware.
Undissolved
detergent coming in contact with flatware
Silverplate is worn off. Exposed base metal takes on a bronzed hue.
Dishwasher cycle not completed
Clogged drain air gap
Water temperature should be at least 140°F (60°C). Set water heater thermostat to a higher setting. Run water at
sink until hot before starting and/or use
Make sure dashes and glassware are loaded so spray reaches all surfaces and items drain properly. Do not ov- erload. Do not nest items.
Make sure large items do not block spray from reaching detergent dispensers.
Check spray arms to make sure they turn freely after load- ing. Be sure a utensil has not prevented theirturning.
Use more dishwasher detergent. Use detergent with high-
est available phosphorus content...especially with hard water.
Use only fresh, dry dishwasher detergent. Store tightly closed box in cool, dry place. Discard old, lumpy deter- gent. Do not fill dispensers until ready to start dishwasher.
If water pressure is low, do not use water for other purposes while dishwasher is running (to assure correct fills).
Check for rainbow hue on glasses. A rainbow hue is the first sign of etching [corrosion of glass). Reduce the amount
of dishwasher detergent. Use a detergent with a lower phosphorus content.
If water pressure is low do not use water for other purposes
while dishwasher is running [to assure correct water fills). Make sure dishes and glassware are loaded properly to
assure adequate rinsing and draining. Do not overload.
Temporary remedy:
1.Set empty dishwasher for a “one wash” cycle.
2.Start dishwasher and unlatch door to stop it when it has filled for the wash part of the cycle.
3.Add l/4 to % cup (120 to 240 mL) of citric acid crystals
(usually available in drugstores).
4.Close and latch door to complete cycle.
Permanent solution: Install an iron or manganese filter to home water supply.
Rinse flatware that is to stand for several hours before washing [use Rinse & Hold). Clean stained items with silver polish and
flatware In the same sllverware basket compartment. Direct contact between these metals can cause perma- nent damage to the sllver.
Remove spots with silver polish. Avoid spilling dry deter- gent on wet flatware.
Remove tarnish with silver polish. Have silver replated
Allow dishwasher to complete cycle.
Some plumbing codes require use of a drain air gap be-
tween an undercounter dishwasher and the drain system of the house. The air gap is usually located above the sink or on the top of the counter near the dishwasher to prevent the possibility of water backing up from the drain into the
dishwasher due to a plugged drain. The drain air gap is
NOT a part of the dishwasher and is NOT covered by the
dishwasher warranty. The drain air gap should be kept clean to insure proper draining of the dishwasher
13
