Whirlpool DU7770XS manual Solution

PROBLEM

Dishes not washing clean

Cloudy film on glassware, etching - permanent corrosion

Dlshes & lnterlor of dlshwasher yellow or brown

CAUSED BY

Water is not hot enough

Improper loading

Spray arm or arms not rotating freely

Nof enough detergent or improper

detergent

“0ld”detergent

Water pressure may be low, dishwasher IS not filling properly

Too much detergent in soft water

Inadequate rinsing

Iron or manganese In water

SOLUTION

Water temperature should be at least 14O’F (60‘C). Set water heater thermostat to a higher setting. Run water at

sink until hot before starting and/or use HI-TEMP WASH Option

Make sure dishes and glassware are loaded so spray reaches all surfaces and Items drain properly. Do nof ov- erload Do not nest items

Make sure large items do not block spray from reaching detergent dispensers

Check spray arms to make sure they turn freely after load- ing Be sure a utensil has not prevented theirturning.

Use more dishwasher detergent. Use detergent with high-

est available phosphorus content. .especially with hard wafer

Use only fresh dishwasher detergent. Store tightly closed container, in cool, dry place. Discard old detergent. Do not fill dispensers until ready to start dishwasher.

If water pressure IS low. do not use water for other purposes while dishwasher is running (to assure correct fills).

Check for rornbow hue on glosses. A rainbow hue IS the flrsf sign of etching (corrosion of glass). Reduce the amount

of dishwasher detergent Use a detergent with a lower phosphorus content

If wafer pressure is low do not use water for other purposes

while dishwasher IS running (to assure correct water fills). Make sure dishes and glassware are loaded properly to

assure adequate rinsing and draining. Do not overload.

Temporary remedy:

1 Set empty dishwasher for a “one wash” cycle.

2 Start dishwasher and unlatch door to stop it when it has filled for the wash part of the cycle.

3Add ‘4 to ’ 2 cup (120 to 240 mL) of citric acid crystals

[usually available in drugstores].

4Close and latch door to complefe cycle.

Permanent solution: Instoll an iron or manganese filter to home water supply

Rust spots			on	Allowing		salty	or
stalnless		steel		acidic	foods		such	OS
-OR-				mayonnaise,			vinegar,
Dark	spots		on	fruit juices,		salad
flatware		-		dressings,		milk
stalnless		steel,		products		to remain		on
sliver	plate,		or	flatware
sterllng				Undissolved
				detergent		coming		in
				contocf	with		flatware
Bronze	tarnish			Silverplate		is	worn	off
on silverplate				Exposed		base	metal
				to kes on a bronzed
				hue

Rinse flatware that IS to stand for several hours before washing [use Rinse & Hold). Clean stained items with silver polish and re-wash Do not put stalnless steel and sliver

flatware In the same sllverware basket compartment. Direct contact between these metals can cause perma- nent damage to the sliver.

Remove spots with silver polish Avoid spilling concentrated detergent on wet flatware.

Remove tarntsh with silver polish. Have silver replated.

Water	left in	Dishwasher	cycle	not
bottom	of	completed
dishwasher		Clogged	drain	air

gap

Allow drshwasher to complete cycle

Some plumbing codes require use of a drain air gap be-

tween on undercounter dishwasher and the drain system of the house The air gap is usually located above the sink or on the top of the counter near the dishwasher to prevent the possibility of water backing up from the drain into the

dishwasher due to a plugged drain. The drain air gap is

NOT a part of the dishwasher and is NOT covered by the

dishwasher warranty. The drain air gap should be kept clean to insure proper draining of the dishwasher