CLEAN SlkNAl LIGHT | W\ATER HEATING | HoLD’DELAY | WASH |
\ | SIGNAL LIGHT | SIGNAL | LIGHT |
DOOR LATCH |
|
|
|
RINSE 81HOLD Cycle
For rinsing a few items to be washed one or more days later. Cycle time is about 15 minutes.
Use AIR DRY only. Do not use
HI-TEMP WASH Option
When this option is selected, water for the main wash and the final rinse is heated to145’F (63°C).
If water is already hot enough, the cycle continues without delay. The WATER HEATING HOLD Signal Light will be on while the cycle delays for water heating.
The AIR DRY Option
Air in the dishwasher is automatrcolly heated during the”dry” part of all cycles except RINSE & HOLD and CHINA CRYSTAL
If the AIR DRY Option is selected, arr In the dishwasher is not heated. Using this option helps save energy, but dishes take longer to dry [over- night) and some water spotting may result.
The RESET OPTIONS Button
If you want to change a selected option, push the RESET OPTIONS Button.
Using DELAY START
1.Push desired Cycle Selector Button.
2.Push desired Option Selector Button(s).
3.Turn Control Knob clockwise to the number of hours [from 1 to 6 hours] you want the dish- washer to delay before the selected cycle starts.
Some items (such as plastics] may need towel drying.
For best results, use a liquid rinse aid such as
4.Close and latch the door. The DELAY WASH Signal Light will come on until the selected cycle starts.
NOTE:
*You can add items while time is counting down. Close and latch the door. The timer will not advance if the door is unlatched.
lRINSE & HOLD and LOW ENERGY WASH Cycles can’t be delayed.
Changing a setting
You can change a setting anytime during any cycle.
1.Lift up on the door latch to unlatch the door and stop the cycle. Don’t open the door until the spray arms stop spinning.
2.Turn the Cycle Control Knob clockwise to the cycle you want.
3.Be sure the detergent dispensers are filled properly for the new cycle.
4.Press door firmly to latch it. The dishwasher
will automatically start the new cycle.
