To add a dish after starting
1.To be sure the added item is washed and rinsed, make sure the Cycle Control Knob has not passed LOW ENERGY WASH.
2.Lift up on the door latch to unlatch the door and to stop the cycle. Don’t open the door until the spray arms stop spinning.
3.Open the door and add the dish.
The CLEAN Signal Light
The CLEAN Signal Light will come on when a washing cycle is complete.
4.Close the door, Do not latch it. Wait 30 sec- onds for air in the dishwasher to warm up. This helps reduce the amount of moisture that can come from the vent when restart- ing the cycle.
5.Latch the door. The dishwasher will Start from where it stopped.
To turn light off, turn the Control Knob clock- wise slightly until the light goes off.
Energy saving tips
You can help save energy if you:
1.Wash full loads. Running a
3.Air dry dishes when You don’t need a rapid drying cycle. Allow longer drying times [overnight).
2 Use the LOW ENERGY WASH Cycle whenever possible. It uses less hot water and energy than otherwash cycles.
4.load correctly for best washing results. In- correct loading may cause poor washing and the need to rewash all or part of the load.
5.Don’t
the recommended amount of detergent for good washing results without hand rinsing.
6.Use your dlshwasher dunng
Local utilities recommend this to avoid heavy usage of energy at certain times of
dav
7.Kitchen cleanup can be done quickly and efficiently through the use of Your dishwasher.
Most appliance parts that can fit in the dish- washer can be cleaned by it.
