DELAY Pad
of this pad adds another hour of delay to the digi- tal display., After 9 hours, touching the DELAY pad will change the display back to 1 hour. The DELAY HOURS indicator will show on the display.
To start the dishwasher during the delay, touch cancel to cancel the existing program; select de- sired program, then touch START.The dishwasher will start immediately.
CANCEL Pad
The CANCEL pad allows you to cancel a program or to clear the display. If the
IIIdishwasher is washing, it will go into a 2
minUte drain automatically before shutting off. If the dishwasher had not been started, it will clear the display.
Changing or cancelling a program
After a program has started, to cancel:
l Touch CANCEL pad once. The dishwasher will
automatically drain for 2 minutes, then shut off.
OR
l Touch CANCEL pad twice. The display will clear
and the dishwasher will immediately shut off.
To restart the dishwasher
l Check detergent dispensers to make sure they are filled properly for the new program.
l Touch STARTto run the dishwasher in the Program Memory.
OR
l Select desired program and options, then touch
START.
Electronic display and status indicators
The electronic | display | shows... | Status | indicators | let | you know what your dish- |
|
|
| washer | is doing | during | a program. |
l The number of minutes remaining in a program (60,59,58 minutes, etc.) represents the WASHING, RINSING and HEAT DRY times. The program time remains the same while the water is heating.
l The number of delay hours selected (1,2,...,9).
The dlsplay also points out operating problems:
WASHING shows on the display during the wash portion of the program. The indicator goes off when the last wash is completed.
RINSING shows on the display during the two final rinses before drying.
DRYING shows on the display during the dry por- tion of the program with the HEAT DRY option.
CLEAN shows on the display when the pro-
gram is complete or immediately after the last rinse when AIR DRY is selected. Opening the door or touching CANCEL clears the CLEAN indicator.
l “PF”shows on the display whenever there has been a power interruption or failure.
l “E4,E2, El or EO” show whenever there has been a control panel malfunction.
Touch CANCEL pad to clear display. The dish- washer may drain before shutting off. If the dish- washer display will not clear or continues to show a code at the end of each cycle, call your
HEAT WATER shows on the display whenever the water is being heated in the POTS & PANS program or when HI TEMP option has been selected.
Whenever the dishwasher is heating water, the digital display will show the water temperature. When the water reaches the proper temperature, the display will go back to showing the remaining program time. NOTE: The program time remains the same while the water is heating.
DOOR OPEN flashes on the display when the door
is unlatched during dishwasher programming or operation. A tone will also beep twice every 3 min- utes for up to 2 hours.
11
