Install | properly.. | . | Remove | sales | labels.. . |
|
|
| Remove the Consumer Buy Gurde label, tape and | ||
|
|
| any inside labels before using the refrigerator | ||
|
|
| To remove any remaining glue: | ||
|
|
| 1 Rub briskly with thumb to make a ball then remove | ||
|
|
| OR |
|
|
|
|
| 2 Soak area with dishwashing detergent solution (1 | ||
|
|
| teaspoon | detergent | in 1 quart warm water] before |
|
|
| removrng glue as described In step 1. |
DO NOT USErubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, car- bon tetrachloride, etc. These can damage the material.
NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under the refrigerator at the front.
I. Allow ‘/2Inch (125 cm] space on each srde and at the top of the refrigerator for ease of rnstallatron.
2.If the refrigerator is to be against a wall, you might want to leave extra space so the door can be opened wider
3.The refrigerator back can be flush against the wall.
Clean it.. .
Clean your refrigerator before using it.
See cleaning Instructions on page 9.
Plug it in...
Level refrigerator-freezer.. .
Levelling Screw AlIll
/
Right to Raise;
Lett to Lower
1 Remove base grille (see page 7 ),
2.To raise front, turn each screw to the right.
3.To lower front, turn each screw to the left.
4.Check with level.
grounding plug
+
Refrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit serving only this appliance be provided
Do not use an extension cord. Use a recep- tacle which cannot be turned off with a switch or pull chain. See Individual electrical require- ments and grounding instruction sheet in your liter- ature package.
4