Changing the light bulbs.. .
WARNING: Before removing a light shield for cleaning or for replacing the bulb, either unplug refrigerator or dis- connect electricity leading to re- frigerator at the main power supply. Shock and injury can occur if eiec- tricity remains connected.
light bulbs behind refrigerator and freezer con- trol consoles:
1 Pull control knob strarght off.
2.Pull bottom of control panel strarght out.
3.Lift top of panel off supports
4 Replace with a 40.watt appliance bulb.
5 Replace panel in reverse order.
Pull Off the Dial; Out at the Bottom
Removing the base grille...
rMetal | Clips 7 | , |
1. Open the doors.
2.Pull grille outwards as shown.
3.Do not remove Tech sheet fastened behind grille 2 Push firmly to snap into place.
3 Close the doors.
Ice cube trays.. .
If cubes are not used, they may shrink. The moving cold air starts a slow evaporation. The longer cubes are stored, the smaller they get.
Optional automatic ice maker.. .
If you have the automatic ice maker accessory or plan to add one later [Part No.
l The ON/OFF lever is a wire signal arm. Down,, .for making ice automatically; Up...toshut off the ice maker.
l Shake the bin occasionally to keep cubes sepa- rated, and to obtain increased storage capacity.
l It is normal for ice crescents to be attached by a corner. They will break apart easily.
On
Lower Signal | Signal | |
Maker. | ||
Arm to Start It. | ||
|
l You will hear water running when ice maker is working. You’ll hear ice fall into the bin. Don’t let these sounds bother you.
To remove ice:
1. Hold tray at both ends.
2. Slightly twist
l The ice maker will noi operate until the freezer is cold enough to make ice. This can take overnight.
l Because of new plumbing connections, the first ice may be discolored or
l If ice is not berng made fast enough and more ice is needed, turn the Temperature control to a higher number. Wait a day and, if necessary, turn the Air Control to a higher number.
l If you remove the ice bin, raise the signal arm to shut off the ice maker. When you return the bin. push it all the way in and lower the arm to the ON posrtion.
l If cubes are stored too long, they may develop an
0 Good water quality is important for good ice quality It is not recommended that the ice maker be con- nected to a softened water supply. Water softener chemicals such as salt from a malfunctioning soft- ener can damage the ice maker mold and lead to poor quality ice. If a softened water supply cannot be avoided, then it is important that the water soft- ener be well maintained and operating properly.
7