Install | properly.. | . | Remove | sales | labels... |
|
|
| Remove the Consumer Buy Guide label, tape and | ||
|
|
| any Inside labels before using the refrigerator | ||
|
|
| To remove any remalnlng glue: | ||
|
|
| 1. Rub briskly with thumb to make a ball then remove. | ||
|
|
| OR |
|
|
|
|
| 2. Soak area with dishwashing detergent solution (1 | ||
|
|
| teaspoon | detergent | in 1 quart warm water) before |
|
|
| removing glue as described in step 1. |
DO NOT USErubbing alcohol or tlammable or toxic solvents, such as acetone, gasoline, oar- bon tetmchlorlde, etc. These can damage the material.
NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTION LABELS INSIDE YOUR REFRIOERATOR.
Do not remove the Tech Sheet fastened under the retrlgemtor at the tint.
I. Allow YZinch (1.25 cm] space on each side and at the top of the refrigerator for ease of installation.
2.If the refrigerator is to be against a wall, you might want to leave extra space sa the door can be opened wider.
3.The refrigerator back can be flush against the wall.
Clean it...
Clean your refrigerator before using it.
See cleaning instructions ~wgeil.
Plug it in...
Level refrigerator-freezer.. .
Plght to Ralre;
Lett to Lower
I. Remove base grille (see page 7).
2.To raise front, turn each screw to the right
3.To lower front, turn each screw to the left.
4.Check with level.
Retrlgerator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit sewing only this appliance be provided.
Do not use an extenslon cord. Use a recep- tacle which cannot be turned off with a switch or pull chain. See individual electrical require- ments and grounding instruction sheet in your liter- ature package.
4