Removing and adjusting
LIFT THE RIGHT SIDE
THEN SLIDE OUT
the freezer shelves...
| To remove | the | shelf: |
|
I | 1. Lifi right | side | of shelf | off supports. |
| 2. Slide shelf out of shelf support holes. | |||
| 3. Replace | in | reverse | order. |
Changing the light bulb...
PW @R
‘:rIL
GRASP LIGHT SHIELD
PULL BOTTOM FORWARD
Automatic ice maker...
There are a few things you will want to know about your ice maker:
l The ON/OFF lever is a wire signal arm. Down...for making ice automatically. Up...to shut off the ice maker.
DO NOT TURN ICE MAKER ON UNTIL IT IS CON- NECTED TO THE WATER SUPPLY.
LOWER | RAISE |
SIGNAL | SIGNAL |
ARM TO | ARM TO |
START IT | STOP ICE |
To adjust the shelf:
1.Remove shelf.
2.Remove supports by sliding upwards.
3.Replace supports on desired level.
4.Replace shelf.
NOTE: The cup shaped supports go in the back of the freezer.
To change refrigerator light:
1.Reach behind the control console to find bulb.
2.Remove bulb.
3.Replace with a
To change freezer light or light above crisper:
1: ;lI;;;;zlight | shield. |
2.Pull bottom of shield forward until it snaps free.
4.Replace with a
5.Press light shield straight on until it snaps into place.
l The dial or lever on the side of the ice maker changes the size of the cubes.
l Shake the bin occasionally to keep cubes sepa- rated, and to obtain increased storage capacity.
l It is normal for ice crescents to be attached by a corner. They will break apart easily.
l You will hear water running when ice maker is working. You’ll hear ice fall into the bin. Don’t let these sounds bother you.
l The ice maker will not operate until the freezer is cold enough to make ice. This can take overnight.
l Because of new plumbing connections, the first ice may be discolored or
l If ice is not being made fast enough and more ice is needed, turn the Refrigerator Control to- ward a higher number. Wait a day and, if neces-
sary, turn the Freezer Control toward C. | 7 |
continued on next | page |
