Utility or Egg Bin
(on some models - Accessory)
Depending on your model, you may have a one piece utility bin or a three piece egg bin. To use the three piece egg bin, remove the cover and place the eggs in the egg tray. Replace cover and store on an interior refrigerator shelf. If you prefer, you can remove the egg tray and place the entire carton of eggs in the bin. Replace the cover.
NOTE: Eggs should be stored in a covered container. If your model does not have an egg bin or covered utility bin, store eggs in their original container on an interior shelf.
Wine or Can/Bottle Rack
(on some models - Accessory)
To remove and replace the wine rack (left) or can/bottle rack (right):
1.Remove the rack by pulling it straight out from the shelf.
2.Replace the rack by sliding it in between the shelf and the wall of the refrigerator.
To turn the ice maker on:
The on/off switch for the ice maker is a wire
NOTE: The ice maker will not make ice until the freezer is cold enough. Allow 24 hours to produce the first batch of ice. Discard the first three batches of ice produced.
To turn the ice maker off:
■Automatic turn off: As ice is made, the ice cubes will fill the ice storage bin. The ice cubes will raise the wire
■Manual turn off: Lift the wire
■To increase ice production rate: Maximum Ice Production (on
some models): In maximum ice production, the ice maker should produce approximately 10 to 14 batches of ice in a
■Normal Ice Production: In normal ice production mode, the ice maker should produce approximately 7 to 9 batches of ice in a
Style 1 - Ice Storage Bin
To remove and replace the ice bin:
1.Pull the covering panel out from the bottom and then slide it back toward the rear.
2.Lift the wire
FREEZER FEATURES
Your model may have some or all of these features. Features that can be purchased separately as product accessories are labeled with the word “Accessory.” Not all accessories will fit all models. If you are interested in purchasing one of the accessories, please call the
Ice Maker and Storage Bin/Bucket
(on some models - Accessory)
Style 1 - Normal and Maximum Ice Maker
MAX
NORMAL
3.Lift up the front of the storage bin and pull it out.
4.Replace the bin by pushing it in all the way or the dispenser will not work. Push the wire
Style 2 - Ice Maker
16