Electrical Requirements
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
Before you move your refrigerator into its final location, it is important to make sure you have the proper electrical connection:
Recommended grounding method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused, grounded electrical supply is required. It is recommended that a separate circuit serving only your refrigerator be provided. Use an outlet that cannot be turned off by a switch. Do not use an extension cord.
NOTE: Before performing any type of installation, cleaning, or removing a light bulb, turn the control, (Thermostat, Refrigerator or Freezer Control depending on the model) to OFF and then disconnect the refrigerator from the electrical source. When you are finished, reconnect the refrigerator to the electrical source and reset the control (Thermostat, Refrigerator or Freezer Control depending on the model) to the desired setting.
Removing the Doors
WARNING
Electrical Shock Hazard Disconnect power before removing doors.
Failure to do so can result in death or electrical shock.
NOTE: Before removing doors, open both doors and remove base grille (see the “Base Grille” section).
Tools Needed:
Z\v in.
1.Unplug refrigerator or disconnect power.
2.If you have a dispenser (ice or water), disconnect water line (behind base grille).
■Remove hose from clip.
■Disconnect union nut and slide it back onto tube.
■Remove metal insert from tube.
■Remove union nut and spring.
3.Remove left top hinge.
■Remove hinge cover and screws. DO NOT REMOVE
SCREW 1 AS SHOWN IN DIAGRAM.
■Disconnect wiring plug and both ground wires.
■Carefully lift door up off bottom hinge. Make sure you protect water line from damage.
Style 1
1
5
