Before using your refrigerator
1. Remove sales labels...
Remove the Consumer Buy Guide label, tape and any inside labels before using the refrigera- tor. To remove any remaining glue:
1.Rub briskly with thumb to make a ball then remove.
OR
2.Soak area with liquid hand dishwashing de- tergent before removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the material.
NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech sheet fastened under
the refrigerator at the front.
2. Clean it...
Clean your refrigerator before using it. See cleaning instructions on page 8.
3. Plug it in...
4. Install properly... | / |
| |
|
|
1L I I |
|
1.Allow Y2inch (1.25cm) space on each side and at the top of the refrigerator for ease of installation.
2.If the refrigerator is to be against a wall, you might want to leave extra space so the door can be opened wider.
3.The refrigerator back can be flush against the wall.
4.Make sure ice maker water supply has been connected. Refer to Installation Instructions.
REFRlGERAiOR | |
POWER CORD | GROUNDING PLUG |
RECOMMENDED GROUNDING METHOD
A 115Volt. 60 Hz.,AC only 15 or 20 ampere fused and properly grounded electrical supply is re- quired. It is recommended that a separate circuit serving only this appliance be provided.
Do not use an extension cord. Use a recepta- cle which cannot be turned off with a switch or pull chain. See individual electrical requirements and grounding instruction sheet in your literature package.
5. Level re’frigerator-freezer...
USESCREWDRIVER
TO ADJUST
FRONT ROLLER
1.Remove base grille (see page 8).
2.To raise front, turn screw in direction shown.
3.To lower front, turn screw in direction shown.
4.Check with level.
5.Replace base grille (see page 8).
4
