Install properly.. .
Remove sales labels.. .
Remove the Consumer Buy Guide label and other Inside labels before usrng the refrigerator. Any glue left can be taken off wrth rubbing alcohol.
NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under the refrigerator at the front.
Clean it.. .
1.Allow % inch (1.3 cm] space on each side and at the top for ease of installation.
2.The refrigerator back can be flush against the watl.
3.If the refrigerator is to be against a wall, you might want to leave enough space so the door can be opened wider.
Clean your refrigerator before using it. See clean- ing instructions on page 9.
Level refrigerator-freezer.. .
Right to Raise; Left to Lower
I. Remove base grille [see page 7).
2.To raise front, turn each screw to the right
3.To lower front, turn each screw to the left.
4.Check with level.
Plug it in.. .
3.prong grounding type wall receptacle
rong
ing plug
RefrigeratorRefrigerotol
Power Cord
RECOMMENDED GROUNDING METHOD
A 115Volt 60 Hz., AC only, 15 or 20 ampere fused electrical supply is required. It is recommended that a
separate circuit serving only this appliance be provided.
Do not use an extension cord. Use a recepta- cle which cannot be turned off with a switch or pull chain. See individual electrical requirements and grounding instruction sheet in your literature package.
4