5.There is no need for routine condenser cleaning in normal home operating environments. If the environment is particularly greasy or dusty or there is significant pet traffic in the home, the condenser should be cleaned every two to three months to ensure maximum efficiency.
If you need to clean the condenser:
■Remove the base grille (see “Base Grille” or “Door Removal” section).
■Use a vacuum with a soft brush to clean the grille, the open areas behind the grille and the front surface area of the condenser.
■Replace the base grille when finished.
6.Plug in refrigerator or reconnect power.
Changing the Light Bulbs
NOTE: Not all appliance bulbs will fit your refrigerator. Be sure to replace the bulb with one of the same size and shape. The dispenser light requires a heavy duty
1.Unplug refrigerator or disconnect power.
2.Remove light shield when applicable as shown.
NOTE: To clean the light shield, wash it with warm water and liquid detergent. Rinse and dry the shield well.
3.Remove light bulb and replace with one of the same size, shape and wattage.
4.Replace light shield when applicable as shown.
5.Plug in refrigerator or reconnect power.
Dispenser Light (on some models)
Reach through the dispenser area to remove and replace light bulb.
Refrigerator Crisper Light or Upper Freezer Light (on some models)
■Remove light shield by grasping the top center of the shield and pulling forward while turning it slightly to one side. If necessary, remove top crisper drawer to access crisper light shield.
■Replace the light shield by inserting the tabs on one end into the slotted holes in the refrigerator or freezer liner. Then, carefully bend the shield at the center to insert the tabs on the other end.
Upper Freezer Light (on some models)
■Remove the light shield by grasping the sides and squeezing in toward the center and while pulling forward the shield.
■Replace the light shield by fitting the tabs into the slotted holes in the freezer liner. Push in the shield until it snaps into place.
Lower Freezer Light Beneath Ice Bin (on some models)
■Remove the light shield by grasping the sides and squeezing in toward the center. Once the side hooks of shield are free from the freezer lining, pull down the shield.
■Replace the light shield by squeezing the sides toward the center and inserting the side hooks into the slotted holes. Once the side hooks are in place, snap the front tab into the slotted hole.
1. Dispenser Light
Refrigerator Control Panel Light
Reach behind the refrigerator control panel to remove and replace light bulb.
Lower Freezer Light Behind Top Freezer Basket (on some models)
■ Depending on your model, remove the top freezer basket or top freezer basket shelf. Remove light shield by removing the Phillips screw on the top of the shield. Carefully, rotate the shield until the left tab can be gently pulled from the freezer wall.
■ Replace the light shield by inserting the left tab into the freezer wall. Align top tab with screw hole and replace screw.
17
