About the controls on the refrigerator.

Your controls will look like one of the following:

FREEZER

4

5

6

3

 

7

2

 

8

 

 

1

 

9

0

 

 

REFRIGERATOR

4

5

6

3

 

7

2

 

8

 

 

1

 

9

0 IS OFF

9 IS COLDEST

9 IS0COLDESTIS OFF

Startup Steps for Proper Temperature Control

STEP 1—Set Fresh Food Control on “5.” STEP 2—Set Freezer Control on “5.”

STEP 3—WAIT 12 HOURS for temperature to stabilize.

STEP 4—If a change is needed, move the control one number at a time and allow 12 hours for temperature to stabilize.

NOTE: Turning the refrigerator to the 0 (off) setting via the controls does not shut off electrical power to the refrigerator.

Control settings will vary based on personal preferences, usage

and operating conditions and may require more than one adjustment.

About Energy Smart™ Models Controls

Energy Smart™ is located on the controls of models equipped with the feature, as shown in the image.

What Energy Smart™ Does

If the ACM (Appliance Communication Module) is connected to your refrigerator and is receiving utility rate information, then Energy Smart™ feature alters the performance of the refrigerator. It minimizes energy consumption when directed by the NucleusTM (separately purchased device) or Smart Meter. The Energy SmartTM feature can cause changes in refrigerator or freezer compartment temperatures and can cause changes in the rate of ice cube production.

Energy Smart™ Override

Press the Energy Smart™ pad for 3 seconds to override the Energy Smart™ feature. The LED above the pad will flash multiple times to confirm a successful override of the feature. This will disable the feature from altering the performance of your unit for 18 hours. Eighteen hours after the feature has been disabled, the Energy Smart™ feature will continue normal operation.

To Change Temperature Control Setting with Touch Pads:

•Freezer setting is on the left side of the display.

•Refrigerator setting is on the right side of the display.

—Press the Warmer or Colder pad for compartment and direction desired.

— Present control setting number will illuminate.

— Each time the pad is touched, compartment setting changes one number.

A display of 1 is warmest and 9 is the coldest setting.

To Turn Cooling Off:

To stop cooling in the refrigerator and freezer compartments, first repeatedly press the Warmer pad for the freezer until its display continuously flashes “1”. Then, using the refrigerator control, repeatedly press Warmer until both displays flash “0”. “0” in both displays turns off the cooling system. On some models, it may be necessary to set only one control to 0 to turn off cooling in both compartments.

NOTE: Turning the refrigerator to the 0 (off) setting via the controls does not shut off electrical power to the refrigerator.

Control settings will vary based on personal preferences, usage

and operating conditions and may require more than one adjustment.

 

Locking the Dispenser (on some models)

 

Press the Lock pad

 

for 3 seconds to lock the

 

dispenser and control panel.

 

To unlock, press and hold

 

the key pads again for 3 seconds.

The temperature controls are preset in the factory at 37°F for the

Setting either or both controls to OFF stops cooling in both the freezer

refrigerator compartment and 0°F for the freezer compartment.

and refrigerator compartments, but does not shut off electrical power

Allow 24 hours for the temperature to stabilize to the preset

to the refrigerator.

recommended settings.

NOTE: The refrigerator is shipped with protective film covering the

 

The temperature controls can display both the SET temperature as well

temperature controls. If this film was not removed during installation,

as the actual temperature in the refrigerator and freezer. The actual

remove it now.

temperature may vary slightly from the SET temperature based on usage

6and operating environment.