Whirlpool EDI9SK manual Install properly, Level refrigerator-freezer, Clean it, Plug it

Install properly...	Remove sales labels...
	Remove the Consumer Buy Guide label, tape
	and	any	inside		labels	before		using the	re-
	frigerator. To remove any remaining glue:
	1. Rub briskly with thumb to make a ball then
	remove
	OR
	2. Soak		area	with	liquid hand			dishwashing
	detergent before removing glue as described
	In step		1.
	DO NOT USE rubbing					alcohol	or	flammable	or
	toxic solvents, such as acetone, gasoline, car-
	bon	tetrachloride,			etc.	These	can	damage	the
	material.
	NOTE: DO NOT REMOVE ANY PERMANENT IN-
	STRUCTIONS LABELS INSIDE YOUR REFRIGER-
	ATOR.
	Do not remove the Tech sheet fastened under
	the	refrigerator		at	the front.

1.Allow % inch (1.25 cm] space on each side and

at the top of the refrigerator for ease of installation.

2.If the refrigerator is to be against a wall, you might want to leave extra space so the door can be opened wider.

3.The refrigerator back can be flush agarnst the wall.

Level refrigerator-freezer.. .

RAISE

1.Remove base grille (see page 7).

2.To raise front, turn legs in direction shown

3.To lower front, turn legs in direction shown

4.Check with level.

5.Replace base grille [see page 7).

Clean it...

Clean your refriger- ator before using it.

See cleaning instruc- tions on page 8

Plug it in...

3-PRONG GROUNDING TYPEWALI. RECEPTACLE\

REFRIGERATOR			J-PRONG			-
POWER CORD			GROUNDING			PLUG
RECOMMENDED			GROUNDING		METHOD
A 115 Volt,		60 Hz., AC only		15 or 20		ampere fused
and	properly		grounded	electrical		supply	is
required. It is recommended					that a separate		cir-
cuit	serving	only	this appliance		be	provided.

Do not use an extension		cord.	Use	a	recepta-
cle which cannot	be turned off		with	a	switch or
pull chain. See individual		electrical	requirements
and grounding	instruction	sheet	in your		literature
package