Changing the light bulb, Removing the base grille

Changing the light bulb...

To change light bulb behind refrigerator consoles:

1.Pull control knob straight off.

2.Pull bottom of control panel straight out.

3.Lift top of panel off supports.

4.Replace with a 40-watt appliance bulb

5.Replace panel in reverse order.

To remove the grille:

1.Open the doors.

2.Pull grille outwards as shown

3.Do not remove Tech sheet fastened behlna grille.

If cubes are not used, they may shnnk The mov-

rng cold air starts a slow evaporation The longer cubes are stored, the smaller they get

PULL OFF THE DIAL;

PULL OUT AT THE BOTTOM

To replace the grille:

1.Line up grille support tabs with metal clips

2.Push firmly to snap into place

3.Close the doors.

To remove ice:

1.Hold tray at both ends.

2.Slightly twist.

If you have the automatic Ice maker accessory, or If You plan to add one later (Part No. ECKMF-62). there are a few things You will want to know

l The ON/OFF lever is a wire signal arm Downfor making ice automatically Up...to shut off the ice maker.

DO NOT TURN ICE MAKER ON UNTIL IT IS CON- NECTED TO THE WATER SUPPLY.

LOWER z

SIGNAL

l The dial or lever on the side of the Ice maker changes the size of the cubes.

9 Shake the bin occasionally to keep cubes sepa- rated, and to obtain increased storage capacity

l It is normal

for

ir@

rroccenk

nitnrhad

corner. They will break apart easily.

9 You will hear water running when ice maker is working. You’ll hear ice fall into the bin. Don’t let these sounds bother you.

l The Ice maker will not operate until the freezer is cold enough to make ice. This can take overnight.

l Because of new plumbing connections, the first ice may be discolored or off-flavored. Discard the first few batches of ice.

continued on next page