Install properly. ,.
‘1. Allow 1/2inch (1.25 cm) space on each side and at the top of the refrigerator for ease of installation.
2.If the refrigerator is to be against a wall, you might want to leave extra space so the door can be opened wider
3.The refrigerator back can be flush against the wall.
Level refrigerator-freezer.. .
Levelling SK4 | 1 |
Front Roller
Right to Raise;
Lett to Lower
1, Remove base grille [see page 7 1,
2.To raise front, turn each screw to the right.
3.To lower front, turn each screw to the left.
4.Check with level.
Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and any lnslde labels before using the refrigerator
To remove any remalnlng glue:
I. Rub briskly with thumb to make a ball then remove.
OR
2.Soak area with dishwashing detergent solution (I teaspoon detergent in 1 quart warm water] before removing glue as described in step 1.
DO NOT USErubbing alcohol or flammable or toxic solvents, such as acetone, gasollne, car- bon tetrachlorlde, etc. These can damage the material.
NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under the refrigerator at the front.
Clean it.. .
Clean your refrigerator before using it.
See cleaning instructions on page 9.
Plug it in...
‘I &prong
I grounding plug
t
Retrigerator
Power Cord
RECOMMENDEDGROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit serving only this appliance be provided.
Do not use an extenslon cord. Use a recep- tacle which cannot be turned off wlth a switch or pull chain. See individual electrical require- ments and grounding instruction sheet in your liter- ature package.
