Whirlpool EHC511 manual Thumb Screws

Removal and cleaning of interior components:

Do not operate unit with panels removed.

I - -

FIGURE 6

1.Remove ice retainer baffle by flexing it (Figure 6) and then slide it off the studs.

THUMB SCREWS

!

FIGURE 7

2.Remove the ‘water pan by unscrewing the two thumb screws (Figure 71.

3.Remove the hose from rhe water pump. Clean the water inlet hose hanging in the water pan.

FIGURE 8

4.Remove the water d,stributor from the freezing plate. It is held in place by rubber end caps. Remove

the inlet hose and clean all water distributor holes an@ the small orfice in the inlet side of the distrib-

utor. When replacing the distributor, make sure the

end caps are located in the evaporator flange

detents and that the water distributor holes face down.

5.Wash the interior components you have just re- moved with mild soap or detergent and warm water. Rinse in clean water. Sanitize in a solution of l/402. (8 ml) of chlorine laundry bleach mixed with 1 gallon (3.8 L) warm water.

NOTE: Do not wash plastic parts in dishwasher.

Plastic parts can not withstand temperatures above 145” F (63°C).

6.Wash the storage bin, door, gasket, and ice scoop with mlld soap or detergent and warm water. Rinse with clean water. Sanitize with the chlorine bleach and water solution.

7. Replace	the interior	components:	water distrib-
utor, hoses,	water pan,	and ice retainer.

8. Check the following:

lHose from water valve is in water pan.

lRubber drain plug is in water pan (Figure 7).

l Water distributor is seated and holes are facing down.

l Hose is reconnected to pump and water distributor.

l Hose from water pan is inserted into storage bin drain opening.

9. Reconnect electrical harness. Replace cutter grid.

5