Before you plug it in
Before using your freezer, you ore personally
responsible for making sure that it...
l is installed and leveled on a floor that will hold the weight, and in on orea suitable for its size and use.
l is connected only to the right kind of outlet, with the right electrical supply and ground- ing. (Refer to your “Electrical Requirements and Grounding Instructions:‘)
l is used only for jobs expected of home freezers.
l
l
l
l
l
l
l
is not near on oven, radiator or other heat source.
is properly maintained.
is in a dry sheltered area.
is used in on area where the room tempera ture will not exceed 110°F(43.3”C).
is not run where there ore explosive fumes.
is not used by children or others who may not understand how it should be used.
is not loaded with food before it has time to get properly cold.
level Chest Freezer...
from end to end and front to bock so that the lid WIII seal properly.
Check with level
1.Check the strength of the floor. It should hold weight of fully loaded freezer
2.Allow at least 3 inches (7.5 cm) air space on sides of freezer and 2 inches (5 cm) at bock. Leave room at top for lid to open all the way.
3.If lid needs to be removed to get freezer through the doorway, follow these steps:
l Check the way the lid sits on the cabinet to help when replacing.
l With Ird closed, remove hinge screws from the co binet.
lLift off lid.
To replace:
l Place lid on cabinet.
l Replace hinge screws. Check to be sure lid gasket is making contact with cabinet on all four sides.
4.Do not cover the freezer with items such as blankets, sheets, tablecloths, etc.
Remove Sales label...
Remove the Consumer Buy Guide label before using the freezer. Remove any left over glue with rubbing alcohol.
Note: DO NOT REMOVE the Core and Ser- vice label on the inside lid. This permanent
label provides immediate information should it be needed. Do not remove Tech
Sheet permanently attached to bock of cabinet.
Clean It...
Clean your freezer before using it. See clean- ing instructions on page 4.
