|
|
|
| A 115 Volt, | 60 Hz., AC only, 15 or 20 | ampere | fused | |||||
|
|
|
| electrical | supply | is | required. | It is | recommended | |||
|
|
|
| that a separate circuit serving only this appliance | ||||||||
|
|
|
| be | provided. | The | receptacle | should not | be con- | |||
|
|
|
| trolled by a wall switch or pull chain. |
| |||||||
|
|
|
| Attach retaining clip over power cord plug from | ||||||||
|
| groundlng | plug | the | literature | package | inside | your | freezer. | Do not | ||
|
| use | an | extension | cord. |
|
|
| ||||
Recommended | Grounding | Method |
|
|
|
|
|
|
|
|
|
|
Using #,*,
your b 0
freezer \z 0 9 Q$
0
Setting the Cold Control...
1.Insert CI corn In the slot of the Cold Control to turn It
2.Turn control to Number 3 This settrng WIII main-
tain zero zone temperatures under normal op- erating condrtlons.
Adjusting Cold Control...
l Turn control to higher number for colder temperatures
l Turn to lower number for less cold temperatures
Exterior Signal light...
automatically warns of any unexpected power failure.
S&gnat light cover
I
Cooling Freezer First. ..
l Allow freezer to cool 6 to 8 hours before filling with frozen food.
l Let it cool overnight before adding large amount of unfrozen food.
Note: When | freezer | is first started | the | compressor |
| ||||
will | run constantly | until the | cabinet | is | cooled. | It | |||
may | take | up | to 6 to | 8 hours | or longer, | depending |
| ||
on | room | temperature | and | the | number | of times |
| ||
the freezer lid is opened.
After the cabinet is cooled the compressor will turn on and off as needed to keep freezer at proper temperature.
The outside of your freezer may feel warm. This is normal. The freezer’s design and main function is to remove heat from packages and air space inside the freezer. This heat is transferred to the room air so the walls of the freezer may be warm.
If the signal light is not glowing, immediately check:
0 for power interruption,
l the power plug; it may be disconnected from the outlet,
l the warning light; it may be burned out.
To replace burned out signal light:
1.Unplug power cord from outlet.
2.Carefully snap out light cover and assembly
with a screwdriver by inserting it under the end of metal edge of the light. Be careful nOI to chip finish on freezer.
3.Unplug burned out signal light and replace with a new one. Signal light con be ordered from your Whirlpool dealer.
4.Then, snap light assembly into place.
5.Plug cord into outlet.
The key eject lock con help reduce the hazard of child entrapment.
To lock or unlock the freezer you must hold the key in the lock while turning. The lock is spring loaded so the key cannot be left in the lock.
If the key is lost, contact your WHIRLPOOL dealer for a replacement.
3
