Install properly... | Remove sales labels... |
|
|
| |||||
| Remove the Consumer Buy Guide label, tape | ||||||||
| and any inside labels before using the re- | ||||||||
| frigerator To remove any remaining glue: |
| |||||||
| 1. Rub briskly with thumb to make a ball then | ||||||||
| remove. |
|
|
|
|
|
|
| |
| OR |
|
|
|
|
|
|
|
|
| 2. Soak | area | with | liquid hand | dishwashing |
| |||
| detergent before removing glue as described | ||||||||
| in | step | 1. |
|
|
|
|
|
|
| DO NOT USE rubbing | alcohol | or | flammable | or | ||||
| toxic solvents, such as acetone, gasoline, car- | ||||||||
| bon | tetrachloride, |
| etc. | These | can | damage | the | |
| material. |
|
|
|
|
|
|
| |
| NOTE: DO NOT REMOVE ANY PERMANENT IN- | ||||||||
| STRUCTIONS LABELS INSIDE YOUR REFRIGER- | ||||||||
| ATOR. |
|
|
|
|
|
|
| |
| Do not remove the Tech sheet fastened under | ||||||||
| the | refrigerator | at | the | front. |
|
|
| |
1.Allow 3 inches (7.5 cm] between overhead cab- inets and the refrigerator top
2.Allow at least an inch (2.5 cm] between the re- frigerator condenser on the back and the wall
3.Allow ‘12inch (1.25 cm) on each side of the re- frigerator for ease of installation.
4.If the refrigerator is to be against a wall, you might want to leave extra space on the hinge side so the door can be opened wider
Level refrigerator-freezer...
Clean it...
Clean your refrigerator before plugging it in or using it. See cleaning instructions on page 7.
Plug it in...
LEVELLING
LEG
RAISE LOWER
1.Keep the 4 bolts that held refrigerator in shrp- ping crate. They are the levelling legs
2.Screw these bolts all the way into bolts holes at the bottom corners of refrigerator.
3.Adjust each leg until the refrigerator won’t rock Slide refrigerator into place
4.Adjust front legs to level the refrigerator.
- To raise corners, turn legs in direction shown
5. Check with level.
REFRIGERATOR |
|
| |||||
GROUNDING | PLUG |
| |||||
POWER CORD |
| ||||||
|
|
|
|
| |||
RECOMMENDED | GROUNDING | METHOD |
| ||||
A 115 Volt, | 60 | Hz, AC only | 15 or 20 | ampere fused | |||
and | properly |
| grounded | electrical | supply | is | |
required. It IS recommended |
| that a separate | cir- | ||||
cuit | serving | only this appliance | be | provided |
| ||
Do not use an extension cord. Use a recepta- cle which cannot be turned off with a switch or pull chain. See individual electrical requirements and grounding instruction sheet in your literature package
Turn it on...
l Move Run Switch to ON.
NOTE: The refrigerator motor will not operate un- til the Run Switch is set to ON.
4
