BeforeUsingYourRefrigerator
1. Clean it
Clean your refrigerator before using it. See cleaning instructions on page 9.
Sprang groundlng typs wall receptacle
2. Plug It In
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused and properly grounded electrical supply is required. It is recommended that a separate circuit sewing only this appliance be provided. Use a re- ceptacle which cannot be turned off with a switch or pull chain. Do not use an extension cord.
See Electrical Requirements and Grounding Instruction Sheet in your Literature Package.
3.Install properly
1.Allow 3 inches (7.5 cm) between overhead cabinets and the refrigerator top.
2.Allow at least an inch (2.5 cm) between the refrigerator condenser on the back and the wall.
3.Allow 1/2inch (1.25 cm) on each side of the refrigerator for ease of installation.
4.If the refrigerator is to be against a wall, you might want to leave extra space on the hinge side so the door can be opened wider.
4.Level refrigerator-freezer
1.Keep the 4 bolts that held the refrigerator in the shipping crate. They are the leveling legs.
2.Screw these bolts all the way into bolt holes at the bottom corners of refrigerator. Roll refrigerator into place.
3.Lower legs just enough to lift rollers off floor.
4.Adjust each leg until the refrigerator won’t rock.
5.Adjust front legs to level the refrigerator.
6.Check with level.
4