Before using your refrigerator
1. Remove sales labels...
Remove the Consumer Buy Guide label, tape and any inside labels before using the refrigera- tor. To remove any remaining glue:
1.Rub briskly with thumb to make a ball then remove.
OR
2.Soak area with liquid hand dishwashing de- tergent before removing glue as described in step 1.
DO NOT USErubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, car- bon tetrachloride, etc. These can damage the material.
NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech sheet fastened under the refrigerator at the front.
ZXan it...
Clean your refrigerator before using it. See cleaning instructions on page 8.
3. Plug it in...
TYPEWALLREC
4. Install properly...
1.Allow 3 inches (7.5 cm] between overhead cab- inets and refrigerator top.
2.Allow at least an inch (2.5 cm) between the re- frigerator condenser on the back and the wall.
3.AllowYz inch (1.25cm) on each side of the refrig- erator for ease of installation.
4.If the refrigerator is to be against a wall, you might want to leave extra space on the hinge side so the door can be opened wider.
5.Make sure ice maker water supply has been connected. Refer to Installation Instructions.
REFRIGERATOR
POWERCORD GROUNDINGPLUG
RECOMMENDED GROUNDING METHOD
A 115Volt, 60 Hz.,AC only 15 or 20 ampere fused and properly grounded electrical supply is re- quired. It is recommended that a separate circuit serving only this appliance be provided.
Do not use an extenslon cord. Use a recepta- cle which cannot be turned off wlth a switch or pull chain. See individual electrical requirements and grounding instruction sheet in your literature package.
5. Level refrigerator-freezer.. .
USESCREWDRIVER
LEVELLINGSCREW TO ADJUST
. RAISE
HTTO RAISE:
LEFTTO LOWEd
1.To raise front, turn each screw to the right.
2.To lower front, turn each screw to the left.
3.Check with level.
4
