Install properly.. . | Remove sales labels.. . |
| Remove the Consumer Buy Guide label, tape and |
| any Inside labels before using the refrigerator |
| To remove any remaining glue: |
| I, Rub briskly with thumb to make a ball then remove. |
| OR |
| 2. Soak area with dishwashing detergent solution (1 |
| teaspoon detergent in 1 quart warm water] before |
| removing glue as described in step I. |
| DO NOT USErubbing alcohol or flammable or |
| toxic solvents, such as acetone, gasoline, car- |
| bon tetrachlorlde, etc. These can damage the |
| material. |
| NOTE: DO NOT REMOVE ANY PERMANENT IN- |
| STRUCTION LABELS INSIDE YOUR REFRIGERATOR. |
| Do not remove the Tech Sheet fastened under |
| the refrigerator at the front. |
1.Allow 3 inches (7.5 cm) between overhead cabi- nets and refrigerator top.
2.Allow at least an inch (2.5 cm) between the refrigerator condenser on the back and the wall.
3.Allow ‘/2 inch (1.25 cm) on each side of the refrigerator for ease of installation,
4.If the refrigerator is to be against a wall, you might want to leave extra space on the hinge side so the door can be opened wider,
Level refrigerator-freezer.. .
Clean it.. .
Clean your refrigerator before using it. -
See cleaning instructions on page 9
Plug it in...
Leveling screw
II
Raise
Right to Raise;
Use ScrewdriverLeft to Lower to Adjust
1.To raise front, turn each screw to the right
2.To lower front. turn each screw to the left
3.Check with level.
Refrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit serving only this appliance be provided.
Do not use an extension cord. Use a recep- tacle which cannot be turned off with a switch or pull chain. See individual electrical require- ments and grounding instruction sheet in your liter- ature package.
4