Install | properly.. | . | Remove sales | labels.. . |
| ||
|
|
| Remove the Consumer Buy Guide label and other | ||||
|
|
| inside labels before using the refrigerator Any glue | ||||
|
|
| left can be taken off with rubbing alcohol. |
| |||
|
|
| Do | not remove | the | Tech Sheet fastened | under |
|
|
| the | refrigerator | at | the front. |
|
Clean it...
1.Allow I/Zinch (1.3 cm) between overhead cabinets and the refrigerator top.
2.Allow “2inch (1 3 cm] clearance against cabinets on each side for ease of installation.
3.If the refrigerator is to be against a wall, you might want to leave enough space so the door can be opened wider.
a... . | i | .. .I ,. I |
Level refrigerator-freezer.. .
Front Roller | Leveling | Screw |
|
|
Use Screwdriver
Clean your refrigerator before using it. See clean- ing instructions on page8.
Plug it in...
Left to Lower
1, Remove base grille (see page 7).
2.To raise front, turn each screw to the right
3To lower front, turn each screw to the left
4Check with level.
t
Refrigerator
Power Cord
RECOMMENDEDGROUNDING METHOD
A 120 Volt, 60 Hz.. AC only, 15 ampere fused elec-
trical supply is required. It is recommended that a
separate circuit serving only this appliance be provided.
Do not use an extension cord. Use a receptacle which cannot be turned off with a switch or pull chain. See Individual electrlcal requirements and
grounding instruction sheet In your literature package.
4
