Optional automatic ice maker.. .
On
Arm to Stop Ice Maker.
Lower Signal
Arm to Start It.
If you have the automatrc Ice maker accessory or
plan to add one later [Part No ECKMF-61, there are
a few things You will want to know
l
The ON /OFF lever is a wire signal arm.
Down., .for making Ice automatically;
Up.. to shut off the ice maker.
l
Shake the bin occasronally to keep cubes sepa-
rated, and to obtain Increased storage capacity.
l
It IS normal for ice crescents to be attached by a
corner. They will break apart easily.
l
You will hear water running when Ice maker
IS
working. You’ll hear Ice fall into the bin. Don’t let
these sounds bother you.
l
The ice maker WIII not operate until the freezer IS
cold enough to make ice. This can take overnight.
l
Because of new plumbing connecttons, the first
ice may be drscolored or off-flavored Discard the
first few batches of ice.
l
If ice is not being made fast enough and more ice
is needed, turn the Temperature Control toward a
higher number. Wait a day and, if necessary. turn
the Air Control toward A.
l
If you remove the ice brn, raise the srgnal arm to
shut off the ice maker. When You return the bin,
push It all the way in and lower the arm to the ON
position.
l
If cubes are stored too long, they may develop an
off-flavor.. like stale water. Throw them away. They
WIII be replaced. Cubes In the ice brn can also
become smaller by evaporation.
Adjusting shelves.. .
Shelves can be adjusted to match the way you use
your refrigerator. II I IIll,
To remove shelves:
I, Tilt up at front
2. Lift up at back.
3 Pull shelf straight out
To replace:
1. Guide the rear hooks into the slots In the shelf
supports.
2. Tilt up front of shelf until hooks drop into slot. Lower
front of shelf to level position.
Changing the light bulb.. .
Before removing the light shield for cleaning or for
replacing the bulb, unplug the refrigerator. Use
apphance bulbs on/y
Push in the Center;
l
Push lightly on the top center of the light shield until
the notched tab unhooks from the control panel.
l
Pull down on the shield until the tab clears the
control panel.
l
Lift the back hooks out of their slots
l
Replace with a do-watt appliance bulb
l
Replace light shield In reverse order
Removing the crispers and crisper covers.. .
l
Slide crispers strarght out to stop.
l
Lift the front.
l
Slide the rest of the way out.
l
Replace in reverse order.
Covers are held in place by two pegs at the back
and two notched tabs In front
Push the Tab
to Clear the Cover.
Snap Back
l
Press front tabs out of the way.
l
Lift cover front.
l
Lift back off the pegs
l
Replace in reverse order.
The center leg can be made shorter or longer to
help level the crisper covers, If necessary. Turn the
leg clockwrse to make It longer Turn It counter-
clockwrse to shorten It.
6