The water dispenser
Chilled water comes from a tank behind the meat drawer. lt holds approximately
1 quart (1 L).
When the refrigerator is first hooked up, press the water dispenser bar with a glass or jar until you have drawn and discarded 2 or 3 quarts (1.9 to 2.8 L). Please allow about 30 seconds to clear the air from the system and for the water to appear. The water you draw and discard will rinse the tank and pipes. Allow several hours to chill a new tankful.
NOTE: The small tray beneath the dispenser
is designed to evaporate small spills. There is no drain in this tray. Do not pour water into it.
To dispense water:
1.Press a sturdy glass against the water dispenser bar.
2.Remove the glass to stop dispensing.
NOTE: Dispense enough water every week to maintain a fresh supply.
The dispenser light
To turn on night light, slide dispenser LIGHT switch to the left. To replace bulb, reach through front of dispenser area. Replace bulb with a
WATERLIGHT
m
Solving common dispenser problems
PROBLEM
Ice dispenser won’t work
Ice dispenser stops working
CAUSE
l Freezer door open
lIce bin not properly installed
l Wrong ice in bin
l Dispenser not used for extended periods, causing ice cubes to melt together
l Ice dispenser bar held in too long
SOLUTIONS
l Close the freezer door.
l Make sure bin is pushed in all the way.
l Use only crescents from ice maker. Shake the bin occasionally to keep cubes separated and to obtain increased storage capacity.
lDump old ice and make a new supply.
9 Wait about 3 minutes for the dispenser motor to reset.
l Large amounts of ice should be taken from the bin, not through the dispenser.
