Adjusting the shelves.. .
1First, remove food from shelf.
2Slide shelf straight out to stop.
3.Lift front.
4.Slide the rest of the way out Replacing Shelf:
I.Fit back of shelf on top of guides with wire stops on the bottom of guides
2.Lift front, slide shelf in until it clears guide stops
Removing crispers and crisper cover.. .
Removing the Crispers:
1 Slide crrsper straight out to stop, lift front, then slide the rest of the way out
2. Replace In the reverse order.
Removing Cover:
1 Lift front and remove the cover support
2. Lift out cover by pulling up and out. Replacing Cover:
1.Fit back of cover into notch supports on walls of refrigerator, then lower front into place
2 Replace cover support with the long tab towards the front Note: If support needs adjustment, turn base right to lower, or left to raise
Shelf Guide
Lift the Front and Pull Again.
Changing the light bulb.. .
WARNING: Before removing the light bulb, either unplug the refrigerator or disconnect
the electricity leading to the re- frigerator at the main power supply. Shock and injury can occur if elec- tricity remains connected.
Automatic ice maker.. .
Raise Signal
Arm to Stop Ice Maker.
Lower Signal
Arm to Start It
If you have the automatic ice maker accessory or plan to add one later [Part No.
lThe ON /OFF lever is a wire srgnal arm Down., .for making Ice automatrcally,
Up...toshut off the ice maker.
l Shake the bin occasionally to keep cubes sepa- rated, and to obtain increased storage capacity.
l It is normal for ice crescents to be attached by a corner. They will break apart easily.
l
l
l
l
l
l
l
1 Reach behind control console to find bulb
2. Remove bulb.
3 Rep/ace wrth opphonce bulb on/y
You will hear water running when ice maker IS working. You’ll hear ice fall into the bin Don’t let these sounds bother you.
The ice maker will not operate until the freezer is cold enough to make ice. This can take overnight. Because of new plumbing connections, the first ice may be discolored or
If ice is not being made fast enough and more ice is needed, turn the Refrigerator Control toward a higher number. Wait a day and, if necessary, turn the Freezer Control toward A.
If you remove the Ice bin, raise the signal arm to shut off the Ice maker. When you return the bin, push it all the way In and lower the arm to the ON posrtion.
If cubes are stored too long, they may develop an
The ice maker water supply should not be soft- ened water. The chemicals could damage the ice maker molds.
6