Whirlpool ETl4EP Changing the light bulb, Optional automatic ice maker, Removing the base grille

Changing the light bulb...

WARNING: Before removing the light shield for cleaning or for replacing the bulb, elther unplug retrlgerutor or dlscon-

nect electrlclty leading to re- frigerator at the maln power supply. Shock and InJury can occur if elec- triclty remalns connected.

Push in the Center;

Pull Down.

Optional automatic ice maker.. .

If you have the automatic ice maker accessory or plan to add one later (Part No. ECKMF-83). there are a few things you will want to know:

l The ON/OFF lever is a wire signal arm. Down.. .for making ice automatically; Up...to shut off the ice maker.

l Shake the bin occasionally to keep cubes sepa- rated, and to obtain increased storage capacity.

l It is nmmal for ice crescents to be attached by a corner. They will break apart easily.

On

Lnurar	Ci		Raise	Signal
PLrrn to	Start It.	-Arm	to Stop Ice	Maker.

1.Push lightly on the top center of the light shield uniil the notched tab unhooks from the control panel.

2.Pull down on the shield until the tab clears the con- trol panel.

3.Lift the back hooks out of their slots

4.Replace with a 40.watt appliance bulb.

5.Replace light shield in reverse order

l You will hear water running when ice maker is working. You’ll hear ice fall into the bin. Don’t let these sounds bother you.

l The ice maker will not operate until the freezer is cold enough to make ice. This can take overnight.

l Because of new plumbing connections, the first ice may be discolored or off-flavored. Discard the first few batches of ice.

l If ice is not being made fasi enough and more ice is needed, turn the Temperature Control toward a higher number. Wait a day and, if necessary, turn the Air Control toward A.

l If you remove the ice bin, raise the signal arm tc shut off the ice maker. When you return the bin. push it all the way in and lower the arm to the Oh position.

l If cubes are stored too long, they may develop an off-flavor...like stale water. Throw them away. They will be replaced. Cubes in the ice bin can alsc become smaller by evaporation.

l Good water quality is important forgood ice quality. It is not recommended that the ice maker be con- nected to a softened water supply Water softener chemicals such as salt from a malfunctioning soft- ener can damage the ice maker mold and lead to poor quality ice. If a softened water supply cannot be avoided, then it is important that the water soft- ener be well maintained and operating properly.

Removing the base grille...

1. Open the doors, I II

			To replace:
			1. Line up grille support tabs with metal clips.
2.	Pull grille outwards	as shown.	2.	Push firmly	to snap into place.
3.	Do not removeTech	sheet fastened behind grille.	3.	Close the	doors.