Install | properly.. | Remove sales labels.. . |
| |
|
| Remove the Consumer Buy Guide label, tape and | ||
|
| any lnslde labels before using the refrigerator. | ||
|
| To remove any remaining glue: |
| |
|
| I, Rub briskly with thumb to make a ball then remove. | ||
|
| OR |
|
|
|
| 2. Soak area with dishwashing detergent solution (1 | ||
|
| teaspoon detergent | in 1 quart warm | water] before |
|
| removing glue as described in step 1. | ||
|
| DO NOT USErubbing alcohol or flammable or | ||
|
| toxic solvents, such as acetone, gasoline, car- | ||
|
| bon tetrachlortde, | etc. These can | damage the |
|
| material. |
|
|
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the retrigemtor | at the front. | / j..Il,lT..rI.>. j | ,l. _‘1 |
~’‘I.es’‘C |
|
1.Allow 3 inches (7.5 cm] between overhead cabi- nets and refrigerator top.
2.Allow at least an inch (2.5 cm) between the refrigerator condenser on the back and the wall.
3.Allow % inch (1.25 cm] on each side of the refrigerator for ease of installation.
4.If the refrigerator is to be against a wall, you might want to leave extra space on the hinge side so the door can be opened wider
? 411 L3 |
Level refrigerator-freezer.. .
1.Adjust each leg until the refrigerator won’t rock.
2.Slide the refrigerator into place.
3.Adjust front legs to level the refrigerator.
-To raise corners, turn legs clockwise.
-To lower corners, turn legs counterclockwise,
4.Check with level.
Clean it...
Clean your refrigerator before using it.
See cleaning instructions on page 8.
Refrigerator
Power Cord
RECOMMENDEDGROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit serving only this appliance be provided.
Do not use an extension cord. Use a recep- tacle which cannot be turned off wlth a switch or pull chain. See individual electrical require- ments and grounding instruction sheet in your liter- ature package.
