Install properly.. . | Remove sales labels.. . |
|
| |||||
| Remove the Consumer Buy Guide label, tape and | |||||||
| any inside labels before using the refrigerator. |
| ||||||
| To remove any remaining glue: |
|
|
| ||||
| 1. Rub briskly with thumb to make a ball then remove. | |||||||
| OR |
|
|
|
|
|
|
|
| 2. Soak area with dishwashing detergent solution (1 | |||||||
| teaspoon | detergent | in 1 quart | warm | water] | before | ||
| removing glue as described in step 1. |
| ||||||
| DO NOT | USE rubbing | alcohol | or | flammable | or | ||
| toxic solvents, such as acetone, gasoline, car- | |||||||
| bon | tetrachioride, | etc. These | can | damage | the | ||
| material. |
|
|
|
|
|
| |
| NOTE: DO NOT REMOVE ANY PERMANENT IN- | |||||||
| STRUCTION LABELS INSIDE YOUR REFRIGERATOR. | |||||||
| Do not remove the Tech Sheet fastened under | |||||||
| the | refrigercrtor | at the | front. |
|
|
|
1.Allow 3 inches (7.5 cm) between overhead cab- inets and the refrigerator top.
2.Allow at least an inch (2.5 cm] between the refrig- erator condenser and the wall.
3.Allow J/Zinch (1.25 cm] on each side of the re- frigerator for ease of installation.
4.If the refrigerator is to be against a wall, you might want to leave enough space so the door can be opened wider.
Level refrigerator-freezer...
Use Screwdriver | Leveling | screw |
to Adjust |
|
|
Lefl to Lower
1.To raise front, turn each screw to the right.
2.To lower front, turn each screw to the left
3.Check with level.
Clean it.. .
Clean your refrigerator before using it.
See cleaning instructions on Page 8,
Plug it in...
Sprang grounding type wall receptacle
I
grounding plug
t Retrigerator Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit serving only this appliance be provided.
Do not use an extension cord. Use a recep- tacle which cannot be turned off with a switch or pull chain. See individual electrical require- ments and grounding instruction sheet in your liter- ature package.
4