Install properiy... | Remove sales labels... |
|
| |
| Remove the Consumer Buy Guide label and any | |||
| Inslde labels before using the freezer. |
| ||
| To remove any remalnlng glue: |
| ||
| I. Rub briskly with thumb to make a ball. then | |||
| remove. |
|
|
|
| OR |
|
|
|
| 2. Soak area with dishwashing detergent solution (1 | |||
| teaspoon detergent | in 1 quart | warm water) | be- |
| fore removing glue as described in step 1. |
| ||
| DO NOT USErubbing alcohol or ttammable or | |||
| toxic solvents, such as acetone, gasoline, car- | |||
| bon tetmchlorlde, | etc. These | can damage | the |
| materlal. |
|
|
|
NOTE: DO NOT REMOVE the Tech Sheet tas- tened under the treezer at the front.
1.Check the strength of the floor It should hold the weight of a fully loaded freezer.
2.Pick a sate place, Indoors, away from In- tlammables such as gasollne.
3.Allow 3 inches (7.5 cm) air space on top of freezer for proper ventilation.
4.Allow at least an inch (2.5 cm) between the freezer condenser, on the back of the unit, and the wall.
5.Allow 1/2 inch (1.25 cm] on each side of the freezer for ease of installation.
6.If the freezer is to be against a wall, you might want to leave extra space on the hinge side so the door can be opened wider.
7.The four bolts that held your freezer in the shipping crate are designed to be the levelling legs. Screw the legs far enough into the bolt holes, in each of the four bottom corners, so the freezer stands about 1 inch (2.5 cm) off the floor
Clean it ... | R |
Clean your freezer | before |
using it. See cleaning instructions on pages6.
Plug it in...
Level freezer... c
Levelllng leg
Lower Rake
I, Keep the 4 bolts that hold freezer in shipping crate. They ore the levelling legs,
2.Screw these bolts all the way into bolt holes at the bottom corners of freezer. Move freezer into place.
3.Adjust each leg until the freezer won’t rock.
4.Adjust front legs to level the freezer.
-To raise corners, turn legs in direction shown.
-To lower corners, turn legs in direction shown.
5.Check with level.
4
Freezer | groundlng | plug |
Power Cord |
Recommended Groundlng Method
.
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit serving only this appliance be provided.
Do not use an extenslon cord. Use a recep- tacle which cannot be turned off wlth a switch or pull chain. See individual electrical require- ments and grounding instruction sheet in your liter- ature package.