Install properly.. | Remove | sales labels... |
|
|
| ||||
| Remove the Consumer Buy Guide label and any | ||||||||
| lnslde labels before using the freezer |
| |||||||
| To remove | any | remalnlng | glue: |
|
|
| ||
| 1. Rub briskly with thumb to make a ball, then | ||||||||
| remove. |
|
|
|
|
|
|
| |
| OR |
|
|
|
|
|
|
|
|
| 2. Soak area with dishwashing detergent solution [I | ||||||||
| teaspoon | detergent | in | 1 quart | warm water] | be- | |||
| fore removing glue as described in step 1. |
| |||||||
| DO | NOT USE rubbing alcohol | or | flammable | or | ||||
| toxic | solvents, | such | as | acetone, |
| gasoline, | car- | |
| bon tetrachlorlde, |
| etc. | These | can | damage | the | ||
| material. |
|
|
|
|
|
|
| |
| NOTE: DO NOT REMOVE the Tech Sheet fas- | ||||||||
| tened | under | the treezer | at the | front. |
| |||
1 Check the strength of the floor. It should hold the werght of a fully loaded freezer.
2.Pick a safe place, indoors, away from in-
flammables such as gasoline.
3 Allow 3 Inches (7.5 cm] air space on top of freezer for proper ventrlation
4 Allow at least an inch (2 5 cm] between the freezer condenser, on the back of the unrt. and the wall
5Allow % Inch (1 25 cm] on each srde of the freezer for ease of Installation.
6If the freezer IS to be against a wall, you might want to leave extra space on the hinge side so the door can be opened wrder
Level freezer...
so the door will stay open at any position
RaiseLower
I, Keep the 4 bolts that hold refrigerator in shrpping crate. They are the levelling legs.
2.Screw these bolts all the way into bolt holes at the bottom corners of refrigerator. Move refrigerator into place.
3.Adjust each leg until the refrigerator won’t rock.
4.Adjust front legs to level the refrigerator
- To raise corners, turn legs in direction shown. ~ To lower corners, turn legs in direction shown.
5.Check with level.
Clean it ...
Clean your freezer before using it. See cleaning instructions on page 6
Plug it in...
Sprang grounding type wall receptacle
Freezer |
|
Power Cord | I PM |
grounding |
Recommended Grounding Method
A 115 Volt, 60 Hz, AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It IS recommended that a separate circuit serving only thus appliance be provided.
Do not use an extension cord. Use a recep- tacle which cannot be turned off with a switch or pull chain. See individual electrical require- ments and grounding instruction sheet in your liter- ature package.
4
