Changing the light bulb... | WARNING: To avoid | possible | shocks, first | unplug |
I | freezer or turn off | electricity | leading | |
to freezer | at the | main power | supply. |
1. Remove the light shield from the side of the control panel Depress the back of the shield to release the tabs, then pull away
2 Replace bulb with a
3. Replace the light shreld. Insert the shield tabs in the slots, then press the shield to snap into place
4 Plug In power cord or switch on electricity
Removing the bottom basket...
To | remove: |
| |
1 Lift front of basket out of supports | Lift the Front, | ||
2 | Pull out. | ||
Then Pull Out. | |||
To | replace: |
| |
1 Positron back of basket on the rear wall supports | |||
2. Lower front into place |
|
The key eject lock...
can help reduce the hazard of chrld entrapment
._..,,I
The signal light...
automatically warns of any unexpected
Signal Light
/
If the srgnal light ISnot glowing, immediately check l for power Interruptron,
l for an unplugged power cord, l for a burned out signal light.
To lock or unlock the freezer you must hold the key In the lock whrle turning The lock IS spring loaded so the key cannot be left In the lock
If the key IS lost, contact your WHIRLPOOL
dealer for a replacement Always give the com- plete model and serial number of your freezer
when requesting a replacement key.
To replace burned out signal light: 1 Unplug power cord from outlet.
2.Open the freezer door.
3.Unplug burned out light and replace with one of same wattage and size. Signal light can be ordered from your WHIRLPOOL dealer,
Part No. 1103680
4.Close freezer door and plug power cord Into outlet.
6