Gas must flow freely through the small hole in the brass orifice for the burner to light properly. This area must be free of any soil and be kept protected from boilovers or spillovers. ALWAYS keep the burner caps in place whenever a surface burner is in use.
After cleaning the gea tube opening, replace
the burner cap and trim ring.
Occasionally check the burner flames for proper size and shape as shown. A good flame is blue in color. If flames lift off ports, are yellow, or are noisy when turned off, you may need to clean the burners. II port8 are clogged, clean with a straight pin. Do not enlarge or distort port. Do not use a wooden toothpkk. lf adjustment is needed, call a qualified technician for service.
To replace burner cap, make sure cap is properly aligned and leveled. Find the recessed locating tabs on the burner cap (see illustration) and place cap over the white ignitor in the burner base.
Turn the burner on to determine if it will light. If the burner doer not light after cleaning, contact an authorized Roper service technician. Do not service the sealed burner yourseff.
Removina the oven door
Removing the oven door will help make it easier to clean the oven.
Burn and Electrical Shock Hazard
Make sure all controls are OFF and the oven is cool before removing oven door.
Failure to do so can resuft in burns or electrical shock
To remove:
1.Open the door as far as it will go.
2.Remove the screws on each side of the oven door.
3.Close the door about % of the way.
4.Lii the door up and off the hinges.
U”U”
B
Typical l urf8ca burner flame
Screw
17
