Whirlpool GDP8500XX manual Dishes not washing clean Water is not hot enough

Models: GDP8500XX

1 24
Download 24 pages 27.39 Kb
Page 19
Image 19
Dishes not washing clean

Dishes not washing clean

Water is not hot enough

Water temperature should be at least 140°F (60°C). Set water heater thermostat to a higher setting. Run water at sink until hot before starting and do not use Lo-Energy Option.

Improper loading

Make sure dishes and glassware are loaded so spray reaches all surfaces and Items drain properly. Do not overload Do not nest items.

Make sure large items do not block spray from reaching detergent dispensers.

Spray arm or arms not rotating freely

Check spray arms to make sure they turn freely after loading. Be sure a utensrl has not prevented their turning.

Not enough detergent or improper detergent

Use more dishwasher detergent. Use detergent with highest available phosphorus content...

especially with hard water.

“Old” detergent

Use only fresh dishwasher detergent. Store tightly closed container, In cool, dry place Discard old detergent. Do not fill dispensers until ready to start dishwasher,

Water pressure may be low, dishwasher is not filling properly

lf water pressure is low, do not use water for other purposes while dishwasher IS runnfng (to assure Correct fills).

Cloudy film on glassware, etching - permanent corrosion

Too much detergent in soft water

Check for rainbow hue on.glasses. A rafnbow hue IS the first sign of etchrng (corrosion of glass). Reduce the amount of dishwasher detergent.

Use a detergent with a lower phosphorus content.

Inadequate rinsing

If water pressure IS low do not use water for other purposes while dlshwasher IS running (to assure correct water fills) Make sure dashes and glass- ware are loaded properly to assure adequate rinsing and draining. Do not overload.

Dishes 8 interior of dishwasher yellow or brown

Iron or manganese in water Temporary remedy:

1. Set empty dishwasher for a “onewash” cycle.

2.Start dishwasher and unlatch door to stop it when it has filled for the wash part of the cycle

3.Add ‘/4to % cup (120 to 240 mL) of citric acid crystals (usually available in drugstores).

4.Close and latch door to complete cycle.

Permanent solution: Install an iron or manganese filter or water softener to home water supply.

Rust spots on stainless steel -OR - Dark spots on flatware: stainless steel, silver plate, or sterling

Allowing salty or acidic foods such as mayonnaise, vinegar, fruit juices, salad dressings, milk products to remain on flatware

Rinse flatware that IS to stand for several hours before washing (use the Rinse & Hold Cycle). Clean starned Items with silver polfsh and re-wash Do not put stainless steel and silver flatware In the same silverware basket compartment. Direct contact between these metals can cause perma- nent damage to the silver.

Undissolved detergent coming in contact with flatware

Remove spots with silver polrsh. Avord spilling concentrated detergent on wet flatware.

Bronze tarnish on silverplate

Silverplate is worn off. Exposed base metal takes on a bronzed hue

Remove tarnish wfth silver polfsh. Have silver reolated.

Water left in bottom of dishwasher above grate

Dishwasher cycle not completed

Allow dishwasher to complete cycle Some remaining water IS normal and keeps seals from dcyfng.

19

Page 19
Image 19
Whirlpool GDP8500XX manual Dishes not washing clean Water is not hot enough