POWER CLEAN* Washing System
Your dishwasher cleans by spraying a mixture of hot, clean water and detergent against soiled surfaces of dishes, When a cycle is started, the dishwasher fills with Water to about the level of the heating element. This water is pumped through the rotating
spray arm&through the POWER CLEAN Module which removes food particles, and back through the rotating spray arms, Soiled water is pumped out and replaced with clean water during a cycle - the number of times depends on the cycle being used.
The POWER CLEAN* Module removes food
particles from the water, stores them, then washes them down the drain.
Load dishes so soiled surfaces face pow- erful spray from rotating arms.
Step-saving preparation for washing
It is not necessary to rinse dishes before putting them into the
dishwasher. Just re- move large pieces, bones, and other hard items. The POWER CLEAN Module will remove food parti-
cles from the water. It contains a chopping de- vice which will reduce the size of food items.
If hard items such as fruit seeds, nuts and egg shells enter the POWER CLEAN Module,
you might hear chopping, grinding, crunch- ing or buzzing sounds. Those sounds are nor- mal when hard items enter the module. DO NOT LET METALLIC ITEMS GET INTO THE POWER CLEAN MODULE.
Water must be hot
For best cleaning and drying resutts, water should be al least 140°F (60°C).
1.Turn on hot water faucet nearest the dishwasher. Let water run until it is as hot as possible.
2.Hold a candy or meatthermometer in the stream of hot water to measure the temperature.
3.If the temperature is too low, have a qualified person raise the water heater thermostat setting.
Check Water
Temperature
‘Tmk.
4
