Before starting your dishwasher

Option Selector Switch

1.Spin the Upper Spray Arm to make sure nothing will stop it from turning freely

2.Close and latch the door.

3.Run hot water at sink nearest dish- washer until it is hot. Turn it off.

1. Make sure Cycle Control Knob points to dot marked HEAVY WASH.

2. Select option.

3. Without turning it, pull the Cycle Con- trol Knob out to start the Cycle.

RINSE&HOLD

USE AIR DRY

1.Turn Cycle Control Knob until it stops at dot marked NORMAL WASH.

2.Select option.

3.Without turning it, pull the Cycle Con- trol Knob out to start the Cycle.

Changing a setting

You can change a setting any-time during any cycle.

1.Unlatch the doorto stop the cycle, but don’t open it until the spray arms stop spinning.

1.Select AIR DRY Option only.

2.Unlatch door and open slightly

3.Pull Cycle Control Knob out.

4.Turn Control Knob clockwise to dot marked RINSE & HOLD.

5.Close and latch the door to start the cycle.

2.With the Cycle Control Knob pulled out, turn clockwise to the cycle you want.

3.Be sure the detergent dispensers are filled properly for the new cycle.

4.Latch the door to start the cycle.