Whirlpool GS440LELB0 Gas and electrical connections, Look for, Anti-tip bracket

COperating position

front leveling leg

rear leveling leg

5.Remove cardboard shipping base from under range. Remove storage drawer. Use a 3/8” drive ratchet to lower rear leveling legs one-half turn. Use channel lock pliers to lower front leveling legs one-half turn.

Before moving range across floor, check that range is still on cardboard shipping base to protect floor covering.

6.Making sure the anti-tip bracket is installed:

• Look for the	anti-tip
anti-tip bracket	bracket
securely attached to		range foot
floor.

•Slide range back so rear range foot is under anti-tip bracket.

Replace storage drawer.

7.If installing the range in a mobile

home, you MUST secure the range to the floor. Any method of securing the range is adequate as long as it conforms to the “Manufactured Home Construction and Safety Standard,” Page 2.

8.Place rack in oven. Place level on rack, first side to side; then front to back.

If range is not level, pull range forward until rear leveling leg is removed from the anti-tip bracket. Use 3/8" drive ratchet and channel lock pliers to adjust leveling legs up or down until range is level. Push range back into position. Check that rear leveling leg is engaged in anti-tip bracket.

Note: Oven must be level for satisfactory baking conditions.

DGas and electrical connections

All connections must be wrench-tightened.

Typical rigid pipe connection

12.Use a brush and liquid detergent to test all gas connections. Bubbles around connections will indicate a leak. If a leak appears, shut off gas valve controls and tighten connections. Then check connections again. Clean all detergent from range.

pressure regulator

90˚elbow

90˚elbow
nipple
union	manual
	gas
	shutoff
black iron	valve

pipe
union	nipple	1/2" to 3/4"
		gas pipe

10.Use 15/16" combination wrench and channel lock pliers to attach the flexible connector to the adapters. Check that connector is not kinked.

13.Center the burner cap on burner base. Burner cap should be level when properly positioned. Place burner grates over burner.

14.Plug power supply cord into grounded electrical outlet.

Typical flexible connection

pressure	use pipe-joint
regulator	compound		manual
	adapter
			gas
		flexible	shutoff
			valve
		connector

adapter	1/2" to 3/4"
use pipe-joint	gas pipe
compound

A 1/2" male pipe thread is needed for connection to pressure regulator female pipe threads.

9.Apply pipe-joint compound made for use with L. P. gas to the smaller thread ends of the flexible connector adapters. Attach one adapter to the pressure regulator elbow and the other adapter to the gas shutoff valve. Tighten both adapters.

regulator shutoff

valve in “on”

position

manual shutoff valve

“open” position

to range

gas supply

11.Check that pressure regulator shutoff valve is in the “on” position. Open the manual shutoff valve in the gas supply line.

Page 5