Whirlpool GS440LELB0 If you need assistance, If you need service, Moving the range

If range does not operate:

Check that the circuit breaker is not tripped or the house fuse blown.

Check that the power supply cord is plugged into the wall receptacle.

Check that gas line is turned on.

See Use and Care Guide for troubleshooting list.

If you need assistance:

If you have questions about operating, cleaning or maintaining your range:

Refer to Use and Care Guide.

Call the Consumer Assistance Center. Check your Use and Care Guide for a toll-free number to call or call the dealer from whom you purchased this appliance. The dealer is listed in the Yellow Pages of your phone directory under “Appliances — Household — Major — Service and Repair.”

If you need service:

Maintain the quality built into your range by calling an authorized service company.

To obtain the name and number of an authorized service company:

Contact the dealer from whom you purchased your range; or

Look in the Yellow Pages of your telephone directory under “Appliances — Household — Major — Service and Repair;” or

Call the Consumer Assistance Center. The toll-free number is listed in your Use and Care Guide.

When you call, you will need:

The range model number.

The range serial number.

Both numbers are listed on the model/serial rating plate located on the frame behind the storage drawer.

Part No. 8523783

© 2002 Whirlpool Corporation

Moving the range:

WARNING

Tip Over Hazard

A child or adult can tip the range and be killed.

Connect anti-tip bracket to rear range foot.

Reconnect the anti-tip bracket, if the range is moved.

Failure to follow these instructions can result in death or serious burns to children and adults.

Benton Harbor, Michigan 49022

When moving range, slide range onto cardboard or hardboard to prevent damaging the floor covering.

If removing the range is necessary for cleaning or maintenance:

1.Remove the storage drawer.

2.Shut off the gas supply to the range.

3.Slide range forward, away from the wall, just far enough to disconnect the gas and electric supply lines.

4.Slide range forward to complete cleaning or maintenance.

anti-tip bracket

range foot

5.Making sure the anti-tip bracket is installed:

•Look for the anti-tip bracket securely attached to floor.

•Slide range back so rear range foot is under anti-tip bracket.

6.Check that range is level.

7.Reconnect gas line to range and check for leaks.

8.Plug power supply cord into outlet. Reinstall storage drawer.

Printed in U.S.A.