Whirlpool GS6NBEXRT00, GS6NBEXRB01 CrisperHumidityControl, ChilledDoorBin, WaterandIceDispensers

CrisperHumidityControl

(onsomemodels)

You can control the amount of humidity in the moisture-sealed crisper. Adjust the control to any setting between LOW and HIGH.

LOW (open) for best storage of fruits and vegetables with skins. HIGH (closed) for best storage of fresh, leafy vegetables.

ChilledDoorBin

(onsomemodels)

Cool air from the freezer is directed to the refrigerator door bin directly beneath the vents.

NOTE: The dairy compartment and can rack are not associated with the Chilled Door Bin feature.

Chilled Door Bin Control

The chilled door bin control is located on the left-hand side of the refrigerator compartment.

A

A. Chilled door bin control

■Turn the control clockwise (right) to reduce the flow of cold air to the bin and make it less cold.

■Turn the control counterclockwise (left) to increase the flow of cold air to the bin and make it colder.

WaterandIceDispensers

(onsomemodels)

WARNING

Cut Hazard

Use a sturdy glass when dispensing ice or water.

Failure to do so can result in cuts.

Depending on your model, your water and ice dispensers may have one or more of the following features: a rotating water dispenser faucet and pull-out tray, a special light that turns on when you use the dispenser, or a lock option to avoid unintentional dispensing.

NOTES:

■Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.

■If your model has a base grille filter system, make sure the base grille filter is properly installed.

■The dispensing system will not operate when the freezer door is open.

■After connecting the refrigerator to a water source, flush the water system by dispensing water into a sturdy container until you draw and discard 1.5 gal. (5.4 L) of water, or for approximately 3 minutes after the water begins dispensing. The flushing process cleans the water system and clears air from the lines. As the air is cleared from the lines, water may spurt out of the dispenser.

■Allow several hours for the refrigerator to cool down and chill water.

■Allow 24 hours to produce the first batch of ice. Discard the first three batches of ice produced.

The Water Dispenser

IMPORTANT: Dispense enough water every week to maintain a fresh supply.

To Dispense Water (Standard):

1.Press a sturdy glass against the water dispenser pad OR place the glass below the water dispenser and press the WATER button.

NOTE: While dispensing water and for 5 seconds after dispensing has stopped, the digital display will show how much water has been dispensed. The default unit is ounces. To switch to cups or liters, press the UNITS button before dispensing.

2.Remove the glass OR release the button to stop dispensing.

To Dispense Water (Measured Fill):

Measured Fill allows you to dispense a specified amount of water with the touch of a few buttons. In Custom mode, you can dispense any amount within a specified range. In Water Bottle mode, you can dispense pre-set amounts according to the size of the container.

NOTE: The exact amount of water you select will be dispensed. Be sure that the container is empty and can hold the entire volume. If ice is in the container, you may need to adjust your selection.

1.Press MEASURED FILL until the light turns on. Press MEASURED FILL again to turn the feature off.

NOTE: The dispenser will automatically turn off Measured Fill after one minute of inactivity. When Measured Fill is turned off, any changes you have made will be lost and all defaults will be restored.

2.Press CONTAINER to change from Custom mode to Water Bottle mode.

6