Whirlpool I-43 manual Tools needed for installation Parts sup lied, Literature package, Panel a

Before you start.. .I

Check the area where you will be cising your portable dlshwasher. Proper installation for operation IS your respcnsibillty Make sure you have everything necessarv to ixure correct operation

ISrequired See Electncui

Important: observe all governing codes and ordinances.

9emove parts and literature packages frcr? dishwasher tub Ciose and latch dfshwasber door

\

Water Heater: Should be sei to deliver 14O’F water to dishwasher for best results

Hot water faucet or hot and cold single-spout water faucet: The faucet should be accessible within 4 feet of the back of the

dishwasher and should provide - 15-I 20 PSI water pressure

Support: The floor must be able to support the appliance weight of 180 pounds.

Drain: To drain your Whirlpooi dishwasher, you need a sink or a laundv tub having a mlnlmum carry-away capacity of 7 gallons per minute. The top of the sink or laundry tub cannot be lower than 27 inches or higher than 48 inches from the bottom of the dishwasher

Tools needed for installation.

Parts sup lied

for insta l?atfon.

1 literature package	4 casters
3 faucet adapter kits

Electrical requirements.

Warning: Improper connection of the equipment grounding conductor can result in a risk of elect&al shuck.

Electrical ground is required on this appliance.

A 120 Volt, 50/60 Hz, AC only 15 Ampere (20 Ampere maximum) fused electrical supply is required. (Time-delay fuse or circuit breaker is recommended.) It is recommended that a separate circuit serving only this appliance be provided.

WARNING: AN EXTENSIONCORD SHOULDNOTBEUSEDWITHTHlS

APPLIANCE.SUCH USEMAY RESULT IN A FIRE,ELECTRICALSHOCK,

OR OTHERPERSONALINJURY

In areas where the recommended voltage is not available, it is necessary to install a transformer with a minimum rating of 1500 watts. The output voltage of the transformer must be 120 volts. If the transformer does not provide for an electrical ground, a separate external grounding wire must be installed in accordance with local codes and ordinances. Such a transfomer can be purchased locally, See Figure I.

120volt

inwt into

Transformer

Figure 1

Recommended grounding method.

DO NOT,UNDERANY CIRCUMSTANCES,REMOVETHE POWERSUPPLYCORD GROUNDING PRONG.

For your personal safety, this appliance must be grounded. This appliance

is equipped with a power supply cord having a 3-prong grounding plug. To minimize possible shock hazard, the cord must be plugged into a mating 3- prong grounding type wall receptacle, grounded in accordance with the National Electrical Code, ANSI/NFPA 70-1987 and local codes and ordinances. See Figure 2. If a mating wall receptacle is not available, it is the personal responsibility and obligation

of the customer to have a properly grounded 3-prong wall receptacle installed by a qualified electrician.

3-prong

grounding type

wall receptacle I-l-iabcb

Groundina

Figure 2

PANEL A