Timer

The Timer can be set in minutes and seconds or hours and minutes and counts down the set time. The Timer does not start or stop the oven.

To Adjust Oven Temperature Calibration (on models with manual oven control):

1.Make sure the oven temperature control knob is in the Off position. Pull oven temperature control knob straight off and turn it over.

To Set:

1.Press TIMER.

The colon will flash during Timer programming.

2.Press the “up” or “down” arrow pads to set length of time.

3.Press TIMER.

The Timer will begin counting down 5 seconds after the time is set.

To display the time of day while the Timer is counting down, press CLOCK. Time of day will be displayed 5 seconds before returning to the Timer countdown.

When there is 1 minute of time remaining, a single tone will sound and the display will begin counting down in seconds.

When the Timer reaches zero, the display will show “End” and four 1-second tones will sound.

To Cancel:

Press TIMER twice in the Timer mode.

Oven Temperature Control

IMPORTANT: Do not use a thermometer to measure oven temperature because opening the oven door and element or burner cycling may give incorrect readings.

The oven provides accurate temperatures; however, it may cook faster or slower than your previous oven, so the temperature calibration can be adjusted. It can be changed in Fahrenheit or Celsius.

A minus sign means the oven will be cooler by the displayed amount. The absence of a minus sign means the oven will be warmer by the displayed amount. Use the following chart as a guide.

ADJUSTMENT °F

COOKS FOOD

(ADJUSTMENT °C)

 

 

 

5° to 10°F (3° to 6°C)

...a little more

 

 

15° to 20°F (9° to 12°C)

...moderately more

 

 

25° to 35°F (15° to 21°C)

...much more

 

 

-5° to -10°F (-3° to -6°C)

...a little less

 

 

-15° to -20°F (-9° to -12°C)

...moderately less

 

 

-25° to -35°F (-15° to -21°C)

...much less

 

 

To Adjust Oven Temperature Calibration:

1.Press and hold CLOCK until the oven display shows the current calibration, for example, “00,” if not yet adjusted, or about 5 seconds.

2.Press the “up” or “down” arrow pads to increase or to decrease the temperature in 5°F (3°C) amounts. The adjustment can be set between 35°F (19°C) and -35°F (-19°C).

3.Press CLOCK to enter the new temperature.

2.Loosen the locking screws inside the oven temperature control knob.

B

A

A. Locking screws

B. Notches

3.Adjust temperature.

To lower the temperature, hold the knob handle firmly and turn skirt counterclockwise to move the tooth a notch to the left.

To raise the temperature, hold the knob handle firmly and turn the skirt clockwise to move the tooth a notch to the right.

Each notch equals about 5°F (3°C).

A B

C

A.Notches

B.Tooth

C.Skirt

4.Tighten the locking screws and replace knob.

Aluminum Foil

IMPORTANT: Do not line the oven bottom with any type of foil, liners or cookware because permanent damage will occur to the oven bottom finish.

Do not cover entire rack with foil because air must be able to move freely for best cooking results.

To catch spills, place foil on rack below dish. Make sure foil is at least ½" (1.3 cm) larger than the dish and that it is turned up at the edges.

8

Page 8
Image 8
Whirlpool IEP314RQ1 Timer, Oven Temperature Control, Aluminum Foil, To Cancel, To Adjust Oven Temperature Calibration