Cisco Systems OL-4580-01 manual Showing Ospf Information, Setting the Transit-Link Delay

Chapter 3 Configuring Open Shortest Path First (OSPF)

Showing OSPF Information

To set the retransmission interval to 10 seconds, enter:

(config-circuit-ip[VLAN6-3.1.2.2])# ospf retransmit 10

To reset the retransmit interval to the default value of 5 seconds, enter:

(config-circuit-ip[VLAN6-3.1.2.2])# no ospf retransmit

Setting the Transit-Link Delay

Transit delay is the estimated number of seconds the CSS waits to transmit a link-state update packet over the OSPF interface. Use the ospf transit-delaycommand to set the transit delay for an interface. Enter a number from 0 to 3600 seconds (1 hour). The default is 1 second.

To set the transit delay to 3 seconds, enter:

(config-circuit-ip[VLAN6-3.1.2.2])# ospf transit-delay 3

To reset the transit delay to the default value of 1 second, enter:

(config-circuit-ip[VLAN6-3.1.2.2])# no ospf transit-delay

Showing OSPF Information

Use the show ospf command to view OSPF information on the CSS. This command is available in all modes. This section includes the following topics:

•Showing OSPF Area Information

•Showing Global Statistics

•Showing IP Interface Information

•Showing Link-State Databases

•Showing ASE Entries

•Showing the Configured Advertised ASE Routes

•Showing the Redistribution Policy

•Showing Summary Route Configuration Information

•Showing OSPF Neighbors

	Cisco Content Services Switch Routing and Bridging Configuration Guide
3-28	OL-4580-01